Jump to content
SAU Community

Recommended Posts

Xbox has the same problem, CPU and GPU heatsinks don't stay clamped down enough and vibrations + heat make the components seperate from the motherboard over time. You can also fix an Xbox by putting it in the oven, but it doesn't always work and you can easily damage the other components on the MB. It fixed my mate's Xbox, though afterwards, his Xbox would occasionally freeze with intense graphic gameplay. Ash's mate reckons $85 but not guaranteed to fix...they use a rework station though which is much safer than ye olde oven lol.

lies, ghetto fixes are always the best

just got back from my first proper ride. still alive!

did ~60ks

hit ~130 on the freeway, was freezing! felt like my chest was being punched in...

wrists raped

talked so much shit to myself i ate most the insides of my mouth/cheeks, gets lonely...

at 100km/h bike sits at just under 9k

/bikes

Ride on Sunday may be a go ahead now...bike is getting serviced this morning, hopefully pick up around midday :)

And yeah you spend a lot of time talking to your helmet, mostly about how bad drivers are.

just got back from my first proper ride. still alive!

did ~60ks

hit ~130 on the freeway, was freezing! felt like my chest was being punched in...

wrists raped

talked so much shit to myself i ate most the insides of my mouth/cheeks, gets lonely...

at 100km/h bike sits at just under 9k

/bikes

It does take a fair bit of energy out of you, even though u guys are buff kents as well, I'm the smallest with heaviest bike :(

Ride on Sunday may be a go ahead now...bike is getting serviced this morning, hopefully pick up around midday :)

And yeah you spend a lot of time talking to your helmet, mostly about how bad drivers are.

Make a thread? :) <3

mostly about how bad drivers are.

Was on melton hwy doing the speed limit this a$shole gets up my arse starts flashing his lights, got out of his way/showed him my finger. 5 seconds later I pull up next to him at the lights, gave him a clap congratulating him on getting so far ahead of me, didnt even have the balls to look my way

On my way home exiting the freeway I stalled the bike taking off uphill at the lights, mint chick stops behind me to make sure I dont get rear ended by someone speeding up the ramp eventhough I waved her to go round, waited there till I got the bike going again.

Moral of the story - there's bad/good drivers just hope I dont come across the bads often

/

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Thanks for doing that Duncan! Makes you a good person in my books. We don't get kangaroos or wombats here. But we have bats and it's similar. AFAIK it's often the mums with a baby attached that get hit because they drop lower when starting from a tree. If you hit an animal, check on it. https://www.ifaw.org/au/resources/wildlife-rescue-app An app to get the closest wildlife rescue contact.
    • My dream is also to have a proper hoist, but I don't think it will ever happen. My quickjack is probably as close as I'll ever get, it really is very good though. 
    • Yeah we keep on in the dailies, it is pretty poor how many animals get hit and the driver leaves without checking....have saved a couple of little ones over the years. Bit of a gruesome job though, pouches generally need to be cut open because they are so tight and often the joey doesn't realise mum is gone so they are still locked onto the teat. I checked the modules in front of the DS wheel where an oil cooler should go.... There is the radar unit - that can go for race use) One of the 2 HX water pumps, the silver cylinder. That needs to be kept but might be able to be relocated But the bad news, the big computer mounted vertically in front of the wheel (blocking any potential air exit) is the electric steering computer. That is required until/unless i do a hydraulic steering conversion, and in CAD based modern car design it is not like I can just pop a big unit like that somewhere else (plus the loom would be too short anywhere else too). So, the passenger side is OK to clear out (just use a smaller washer reservoir, potentially elsewhere), but the DS no beuno
    • Well, all the best with the new camry It was interesting to hear about the UK process, it is generally a lot more streamlined here with a shipping agent looking after all the import side (noting the exact final price can still be a surprise.....) and I've used a few different brokers on the japan (or US) side, and never had any trouble with any of them....luck of the draw I guess. You mentioned you didn't get the auction sheet (understandable since you bought it from a dealer, not auction), but I always try and get hold of that because they are pretty thorough. I've imported 2x R grade vehicles over the years and both were fine, repairs in Japan are pretty thorough compared to here in Oz.
    • BTW I measured the jack I have, it is 70mm at the saddle but you only have about 700 until it returns to 150mm high at the cylinder so it is good but no magic bullet.
×
×
  • Create New...