Jump to content
SAU Community

Recommended Posts

so, work shop i know of, that my car once sat at for a couple weeks got raided, and was full of heroin this morning......

At least we now know why your coilovers are so tight... its been modified to carry gold bars and bricks of heroin

They're digging up the back yard to look for potential stashes, so it actually is earth shattering

U r 1 cheeky kunt m8

I remember meeting the guy from that shop once lol

Edited by HEKT1K

Are they supposed to be any good?

Yeah, like 15 years ago :P

I had 10 year old Tein HA's on my old 33 doe(Last version with the gold pillowball tophats). They were in awesome shape when I got em. 7kg springs all around, stupidly stiff on the hardest damper setting but pretty comfortable on lower settings. Ended up selling them for the same coin I paid for them too.

so, work shop i know of, that my car once sat at for a couple weeks got raided, and was full of heroin this morning......

What'd you think all these asians were paying for all these mad cars with...hard work?

Heard about that. Epping? Only a $6m haul, nothing earth shattering

Not when compared to your pay packet

Going to one of these cook your own steak stone grill joints tomorrow

I still don't see the point to this shit... I go to a restaurant, pay for a steak and have to cook it myself... Pretty sure I can do that at home

  • Like 1

Going to one of these cook your own steak stone grill joints tomorrow

I still don't see the point to this shit... I go to a restaurant, pay for a steak and have to cook it myself... Pretty sure I can do that at home

Used to say that before I tried them, but am a changed man. Can't guarantee it'll be awesome unless you're going to Paesano, but...

Steak stays hot throughout meal, comes out very quick, steak remains very juicy throughout even cooking it well done, don't have to clean up anything afterwards or prepare, pretty well guaranteed a good cut cause they can't hide the appearance by cooking it, yada yada yada you'll wake up tired the next day.

Used to say that before I tried them, but am a changed man. Can't guarantee it'll be awesome unless you're going to Paesano, but...

Steak stays hot throughout meal, comes out very quick, steak remains very juicy throughout even cooking it well done, don't have to clean up anything afterwards or prepare, pretty well guaranteed a good cut cause they can't hide the appearance by cooking it, yada yada yada you'll wake up tired the next day.

I've never had a steak go cold on me, apart from the 1kg challenge I did...

What if you're no good at cooking steak...?

And if you go to a good steak restaurant /good restaurant in general, your steak will be juicy

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...