Jump to content
SAU Community

Recommended Posts

4K, pointless at this stage

3D, pointless since they were launched like 5 years back

65"... unless you've got a big room, the 480p/720p/1080p content you'll be playing on it will not be as sharp as it should be.

Would still bang, but not for that price

For the difference in price, I'd be going for this... then upgrading in a few years to a good TV once 4K porn is actually available

https://www.kogan.com/au/buy/kogan-50-led-tv-full-hd-za/

3D is not to bad, good for movies at home

Everyone will always want bigger tvs when they do get cheaper, no matter how much room they have lol

Buy $70 of wolfblass wine first = $370 tv and wait 20 weeks for it fkn lol

I'll stick with my 70" Sony FHD, which I still think is the best value:quality TV out at the moment. A bit over $2k and clear as day :)

1423095314.4166.iPicit.jpg

Buy $70 of wolfblass wine first = $370 tv and wait 20 weeks for it fkn lol

I'll stick with my 70" Sony FHD, which I still think is the best value:quality TV out at the moment. A bit over $2k and clear as day :)

This is what is in our lounge room, $2k from jb on boxing day sales

  • Like 1

Birds I was looking at that TV for my joint.. tossing up between the 60 or 70 (850B right?)

60 is like 1k cheaper than the 70 though.. how you find it?

http://www.rtings.com/info/television-size-to-distance-relationship

have a look at veiwing distance before you buy a tv too man. i have a 60 in the bedroom (just cos its a spare) and f**k its pointless.

Birds I was looking at that TV for my joint.. tossing up between the 60 or 70 (850B right?)

60 is like 1k cheaper than the 70 though.. how you find it?

Yeh 850B I think

Go the 70, the extra 10 inches is a big difference.

Depends on room size to an extent, but my lounge isn't that huge. Feel free to pop by and see / measure how far away I sit. With the 70" you can sit pretty far back, so more people can watch it at same time without a crappy viewing angle = great for boys nights in. Have sat 2 metres away from it playing COD and it's still very clear looking.

This is what is in our lounge room, $2k from jb on boxing day sales

Good tv hey! You got a bargain. Think mine was a few hundred more a few months before the end of last year.

I used to have my 55" at the end of my bed and it was ridiculous. Your eyes have to move constantly to watch what ever is on the screen and it's even worse when playing Playstation.

This is good for 1st person shooters where you already dart eyes everywhere, but annoying for everything else.

This is what is in our lounge room, $2k from jb on boxing day sales

I don't suppose you'd still have the receipt and could send me a picture of it so I can try and weasel them down to that?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...