Jump to content
SAU Community

Recommended Posts

  • Replies 231
  • Created
  • Last Reply

Top Posters In This Topic

to run a 10 in a full weight gtst, you will need good tyres, try aim for something better then ET street radials because they wont cut it, about 375rwkw, a good clutch and also a decent launch control and ecu with a tuner who can sit with you at the track and play with boost control trim on gears, boost control trim on wheel spin, and ignition timing retard on wheelspin, and also the launch control must not spool too much boost off the mark.

you need a 1.6 or lower 60 foot before you will grab it also.

Its not easy to do on a full weight street car, but i never gave up until i cracked it, i ran 10.80 @ 135mph before i gave up.

if you want to run the 10 you need to put in some hard work!

Except it hasn't done a 10 yet :P

I differ in opinion to most people who want to run 10s

A single 10.9999999 is different to a car setup to run half a dozen in a row. That is where car setup is important

I also don't like to see people wanting a 10 sec streeter but not want to drag "race" ie something other than a off street Wednesday night

I understand not everyone wants to cage their car....

If you don't, set it up to run consistent low 11's and hit the track as much as you like

That's gotta be one* of the dumber things you've posted.

*aside from the 2JZ/Supra talk on a RB/Skyline based forum

If someone wants a street car, on DOT radials that can run a 10.

And drive it around daily, for a reasonable budget - who cares about a "real" comp.

That's gotta be one* of the dumber things you've posted.

*aside from the 2JZ/Supra talk on a RB/Skyline based forum

If someone wants a street car, on DOT radials that can run a 10.

And drive it around daily, for a reasonable budget - who cares about a "real" comp.

LOL I agree with that one, that Zebra seriously needs to go back to the zoo! ..Saying after reading some of his posts..>_<

ahhh you guys are f**king retarded >_<

you guys want to spend 11ty $$$$ on getting a car to run a 10...ONCE..because you will be booted...then what....spend more money on changing it to a circuit car

Silly me for thinking people who want a "10 second car" actually want to run 10's more than once.

Its like buying a V8 Commodore.... Its no special supercar out of the factory, not unless you buy something really expensive..

But hey if you want a V8 taxi then thats good for you. On the same token if somebody wants a 10 second skyline for the sake of saying I have a 10 second skyline then good for them too LOL

*aside from the 2JZ/Supra talk on a RB/Skyline based forum

Oh Noez!!!!

God Forbid any variety on the internet....Don't tell me you snatched the rights to "Nissan Skyline" too so you can claim it as your own and make money of others hard work

i thought WSID was introducing the new rule cause heaps of owners of new Fords & holdens where complaining about putting cages in there brand new $80K cars..

most these cars can run 10's for under $5000 of mods..

to run a 10 in a full weight gtst, you will need good tyres, try aim for something better then ET street radials because they wont cut it, about 375rwkw, a good clutch and also a decent launch control and ecu with a tuner who can sit with you at the track and play with boost control trim on gears, boost control trim on wheel spin, and ignition timing retard on wheelspin, and also the launch control must not spool too much boost off the mark.

you need a 1.6 or lower 60 foot before you will grab it also.

Its not easy to do on a full weight street car, but i never gave up until i cracked it, i ran 10.80 @ 135mph before i gave up.

if you want to run the 10 you need to put in some hard work!

Ive gone the easy way and have a C4 and 3800 stall. But dont have the 10 yet but shouldnt be far away :thumbsup:

Most people also don't realise how quick a 10 second car is. Fastest car i've ever been in was my dads R33 with 350rwkw, did a low-mid 11 @ 125mph which was freaking quick. Not saying this about OP, but a lot of guys go from a stock liner and think "oh i want a 10 second car hepa derpa" without knowing how quick it really is.

i thought WSID was introducing the new rule cause heaps of owners of new Fords & holdens where complaining about putting cages in there brand new $80K cars..

most these cars can run 10's for under $5000 of mods..

Nope, they did a backflip on the decision unfortunately

never happen on street tyres

drag radials as a minimum and you would be looking at 550+bhp at the crank to get you a high 10 at around 130mph after lots of practice

Auto or manual?

Lots of practice.... PFFT I did one pass :nyaanyaa: But I guess it wasn't a 10 :pirate:

In a manual, you would need atleast 400rwkw and MT Streets and know how to drive. Really drive.

I had 360rwkw (dyno dynamics) or 410rwkw (dynapac with correction) and yes knowing how to peddle well and smash gears helps

to run a 10 in a full weight gtst, you will need good tyres, try aim for something better then ET street radials because they wont cut it, about 375rwkw, a good clutch and also a decent launch control and ecu with a tuner who can sit with you at the track and play with boost control trim on gears, boost control trim on wheel spin, and ignition timing retard on wheelspin, and also the launch control must not spool too much boost off the mark.

you need a 1.6 or lower 60 foot before you will grab it also.

Its not easy to do on a full weight street car, but i never gave up until i cracked it, i ran 10.80 @ 135mph before i gave up.

if you want to run the 10 you need to put in some hard work!

I don't think you need a lot of the things you have listed >_<

Most people also don't realise how quick a 10 second car is. Fastest car i've ever been in was my dads R33 with 350rwkw, did a low-mid 11 @ 125mph which was freaking quick. Not saying this about OP, but a lot of guys go from a stock liner and think "oh i want a 10 second car hepa derpa" without knowing how quick it really is.

Also on the street a 10sec car isn't really a 10sec car... Unless it's a GTR :)

Edited by SimonR32

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...