Jump to content
SAU Community

Recommended Posts

:woot: Wow 20/100?! On eflex my economy is around 15.7/100 ;) but id imagine the higher the ethanol content the higher the consumption

My economy went to crap with the switch to United and these cold starts aren't helping. More cranking enrichment, twice the fuel at under 20 degrees and it still isnt perfect. It takes a lot of fine tuning to get it spot on, I don't know how Trent does it so easily.

greddy type s coilovers (6/8 on hardest setting), castor bushes, swaybars, pineapples and nismo 1.5 diff

tyres = 235/40/18 Nitto NT-05

I have done all my suspension but i think its a bit stiff in the rear, i also have the Nismo 1.5 way (amazing diff), i guess a decent set of tyres should do the trick by the sounds of it!

greddy type s coilovers (6/8 on hardest setting), castor bushes, swaybars, pineapples and nismo 1.5 diff

tyres = 235/40/18 Nitto NT-05

Nice I have done all that an a few other things, do you reccomend the types s coilovers, mate had them in hos 34r but haven't been in gtst with them

Nitto nt05 is a great tyre, I couldn't get them in the right size in 17 diameter though so went with Yokies ad08. Grippy as all hell.

I'm hoping to join the club in the next couple of weeks, my WMI kit has arrived so I'll install this week and get it tuned soon after. Should nudge me into the 300 club ;)

greddy type s coilovers (6/8 on hardest setting), camber bushes, swaybars, pineapples and nismo 1.5 diff

tyres = 235/40/18 Nitto NT-05

haven't you also got no camber on the rear Joe...??

castor bushes wont make any difference to rear wheel grip.. :rofl:

lol... i wrote camber and castor, and then realised that we aren't really talking about the fronts here so i deleted it.... must have deleted the wrong one.

i only have camber bushes on the rear. it's not flat, but it's reasonably close

How can you people get such good fuel economy with 300ish rwkw? My daily driver R34 200rwkw ALWAYS gets 19-20L/100kms, it is seriously REALLY f*ked. My right foot is not too bad, just the ocassional squirt to 5-7k rpms in 1st, 2nd and 3rd lasting less than 10 seconds.

Haha ive seen how u drive. U should buy a prius

My right foot is not too bad

Yes, yes it is. Either that or it's the tune.

There are only two factors really, but im guessing it's a foot problem.

And my figures quoted earlier - that wasn't using the O2 sensor. That was with it disabled and the tune adjusted to suit.

400rwkw rb26 would be more appropriate as 350kw is about the norm isnt it

lol... i wrote camber and castor, and then realised that we aren't really talking about the fronts here so i deleted it.... must have deleted the wrong one.

i only have camber bushes on the rear. it's not flat, but it's reasonably close

I actually thought that may have been the case. ;)

aalright after my embarresing 35r result ive scraped that setup and now got me a 3076r 6 boost and tial 44mm will be ran on pump results shouldnt be all that far away

I run a 6Boost, tial 44mm and 3037.... Car only made around 311rwkw on 17psi, so you should be able to get in the club ;) or just run E85 as it made 340rwkw on the same boost etc ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I hope it's actually possible. This is a write off in insurance world.
    • Yup. 2-way with shallow ramp angles. Still works.
    • That was the first session so not a lot to take from the day. It was low 20s ambient and the coolant had got to 110 (and obviously had some pressure!) so that still needs to be addressed. I haven't downloaded the data yet but will. I had refilled the auto trans with Redline DT6 because it claimed the best viscosity I could find at 100o. It wasn't really long enough to get a good feel for that; while the trans got to 100o in the session it still wasn't shifting crisply as I hoped. I think I'll try a few more sessions before judging. No steering motor overheat but I'd hope not in only 1 session! But finally the suspension; it was night and day over the standard stuff and the car was a couple of seconds quicker on the same crappy tyres, which is a huge difference. I'll stick with that and get some sway bars and a mechanical diff sorted too and see how that all goes together
    • I guess it’s partially a compromise of how my car is used, wanting to be able to switch from drift to grip with track side on-car adjustment. Also partially with the way the knuckles are set there is more static camber but less dynamic camber gain. 
    • OK, so update from the track day on Friday It was a classic "an unfortunate series of events'. There were a few cars around and when i checked my mirror coming out of the fish hook I notice some smoke from the rear of mine. Looked again and it was getting much worse, I figured I'd blown a turbo or something to got off it and pulled off the racing line. However.... since it is a left hairpin into a right kink, I was on the inside of the next corner. There was a car passing me on the left and a big drop off over the ripple strip on the right......and someone had knocked the witch's hat that was on the apex about 1m onto the track. So, between those 3, I decided to mow down the cone and not damage my car/the other car. Right choice, but surprising result.  The car decided the cone was a small pedestrian so it blew the rear bonnet hinges up to protect their head in the upcoming person to car impact....I didn't see that coming and like an airbag deployment it happened super fast. Straight into the pits from there, everything was driving fine but it became clear it was a coolant leak not smoke, it was billowing up onto the windscreen. Onto the trailer and home. I'll do a separate thread about the repair (once I work out what it is ), but the immediate problem was the bonnet wouldn't open because the front was pinched onto the front bar and would not release. Ultimately we unbolted the hinge from the bonnet, pulled it back a little and it released from the front OK. "There's your problem", the top radiator hose had popped off at the radiator.
×
×
  • Create New...