Jump to content
SAU Community

Recommended Posts

Back on topic found this wish it had the strut bar and other side awesome that it has the brake stopper build into it attachicon.gif20160616_210205.jpg

Tell us more about the bronze 19in LMGT4 in the background.. Is that a pic or an actual wheel?

  • Like 2

Tell us more about the bronze 19in LMGT4 in the background.. Is that a pic or an actual wheel?

Eagle eye ! Not much to tell has a little bit of nismo on it much much more to go on ! This pic nismo lmgt4 19x10.5 +15 with nismo extensions and nismo flares with nismo wheel nuts d565f08c001868c5396f10f566c196b3.jpg
  • 2 weeks later...

I found something cool while hunting for Nismo relics - a Nismo (VISA) Club Credit Card. This gives you discount to events, invites to nismo festival and has a rewards system too. The black card is a 'Club Nismo' which gives you a larger discount then the silver one. This is from 2004 by the way.

post-100746-0-77948100-1467169749_thumb.png

  • Like 1
  • 3 weeks later...

For the real Nismo nuts.....

http://www.nismo.co.jp/products/catalogue_2016/#page=61

Full Nismo TI exhaust announced for the R32 and R34 GTR's.

Priced at a nice $7000 for the front pipes back, and an additional $3500 for the front pipes it is eye watering expensive. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Nah. You need 2x taps for anything that you cannot pass the tap all the way through. And even then, there's a point in response to the above which I will come back to. The 2x taps are 1x tapered for starting, and 1x plug tap for working to the bottom of blind holes. That block's port is effectively a blind hole from the perspective of the tap. The tapered tap/tapered thread response. You don't ever leave a female hole tapered. They are supposed to be parallel, hence the wide section of a tapered tap being parallel, the existince of plug taps, etc. The male is tapered so that it will eventually get too fat for the female thread, and yes, there is some risk if the tapped length of the female hole doesn't offer enough threads, that it will not lock up very nicely. But you can always buzz off the extra length on the male thread, and the tape is very good at adding bulk to the joint.
    • Nice....looking forward to that update
    • Neg, the top one is actually for the front. The sizes are 18x10.5 +18 and 18x11 +32.   I measured many times but I'm sure I'll have problems as this is the thread for problems.
    • Just one thing; tapping tapered threads is tricky. Taps are always tapered and you would generally run it as far as you can, but with a tapered thread you have to stop much sooner otherwise the wide part of the taper will run in too far and you will have to thread the sensor in too far too as well (possible that it will never make a good seal) BTW nice wide wheels, I guess the top one is for the back!
    • Welp, good to know. Will have to wait awhile until steady hands with drills and taps are available. In other news, these just arrived! I will weigh them for posterity. Edit: 11kg each (or 10.9/11.1 depending on what my scale decides over multiple tests, the 18x11 don't seem to weigh noticeably any more than 10.5)  
×
×
  • Create New...