Jump to content
SAU Community

Recommended Posts

With all the massive power being made, I think it's time for a 500+kw(wheels) to see what has been tried and tested, and to compare combinations, similar to the 400kw thread.

List as much of your mods as you wish as the more info the better: engine, turbo,cams, boost etc etc

I will start:

RB26 stock block

Apexi SPL V-Max 73.7mm billet crank

Apexi SPL V-Max rods

HKS Step 3 87mm with 22mm pins

Apexi SPL V-Max 290 11.5mm cams

Apexi SPL V-Max Springs, retainers & lifters

Supertech +1mm valves

9.0:1 CR

HKS twin GT3240 + twin gates turbo kit

Trust sump (modified)

External single stage Moroso oil pump (wet)

Apexi SPL V-Max Drag intercooler (150mm)

3" dumps > single 85mm exhaust

Microtech LT12S

3 x 044's + large surge tank

6 x Bosch Indy Blues

Caltex E85

520rwkw on 22psi on a very safe tune, no cam timing, and low rev limit.

Plenty more in it with more tuning, boost, revs and cam timing, but this will do for now.

Link to comment
https://www.sau.com.au/forums/topic/411489-500kw-club/
Share on other sites

RB30/25DET

NITTO/JE pistons 22mm pins

NITTO I beam rods

NITTO 1.2mm Drag headgasket

ARP Main studs

ARP Head studs

Nismo Engine mounts

9.5L ASR sump

Moroso external oil pump

ROSS Harmonic balancer with pump drive kit

Ported head

HKS 256/264 cams

Greddy Plenum

Q45 throttle body

Speedfab Exhaust manifold

Twin TIAL 36mm Wastegates

HKS T51R KAI turbo

4inch Custom turbo back exhaust

100mm Intercooler

52mm Alloy rad

SPAL 16inch thermo

2000cc ID/Bosch Injectors

SX Fuel reg

Twin entry fuel rail

2x Bosch 044 Fuel pumps

Nismo Intank Fuel pump

3L Surge tank.

E85 Fuel

Standard RB25DET gearbox

JB Single plate Full Monty clutch

Tomei Trax 2 way LSD

Supporting mods etc etc etc

547rwkw@25psi

Trapped 137mph on a practise run then blew the diff. :(

Link to comment
https://www.sau.com.au/forums/topic/411489-500kw-club/#findComment-6577905
Share on other sites

Dave's list in black!!!

RB30/25DET

NITTO/JE pistons 22mm pins

NITTO I beam rods

NITTO 1.2mm Drag headgasket

ARP Main studs

ARP Head studs

Nismo Engine mounts

9.5L ASR sump

Moroso external oil pump

ROSS Harmonic balancer with pump drive kit

Ported head

HKS 256/264 cams

Greddy Plenum

Q45 throttle body

peedfab Exhaust manifold

Twin TIAL 36mm Wastegates

HKS T51R KAI turbo

4inch Custom turbo back exhaust

100mm Intercooler

52mm Alloy rad[/font][/color]

SPAL 16inch thermo

2000cc ID/Bosch Injectors

SX Fuel reg

Twin entry fuel rail

2x Bosch 044 Fuel pumps

Nismo Intank Fuel pump

3L Surge tank

E85 Fuel

Standard RB25DET gearbox

JB Single plate Full Monty clutch

Tomei Trax 2 way LSD

Supporting mods etc etc etc

547rwkw@25psi

Trapped 137mph on a practise run then blew the diff. :(

Link to comment
https://www.sau.com.au/forums/topic/411489-500kw-club/#findComment-6578235
Share on other sites

Full boost at around 6,300. Only revving it to 8,750 for now. will lift it to 10K when it is re-tuned later.

Traction? What traction? :D I have only driven it in RWD as my attesa isn't working and on stock wheels and tyres.

Link to comment
https://www.sau.com.au/forums/topic/411489-500kw-club/#findComment-6579526
Share on other sites

Power was still increasing at 8750 and on previous tunes (with smaller turbos) power keeps rising steadily to 10K. We have found that rwhp output for HKS turbos can match the HKS rated figures of their turbos. The GT3240's are rated at 580hp each (@1.4 bar). On an RB26 in twin form, they need to be pushed hard (around 2.5 bar) to get over 1000rwhp.

Link to comment
https://www.sau.com.au/forums/topic/411489-500kw-club/#findComment-6580969
Share on other sites

The 3240 is basically a 3540 with a cutback rear wheel, fitted into a GT30/28 rear housing (0.87).

With E85 and an RB30 I am not surprised you're making 750+hp @ 1.7bar with a large HKS single. I would love to swap to 0.73 rears or even 0.61's as the 3240's only come in 0.87

My tuna thinks that 2.5 bar is what it will need to get to 1000.

Link to comment
https://www.sau.com.au/forums/topic/411489-500kw-club/#findComment-6580977
Share on other sites

  • 1 month later...

Hi everyone,

About time we posted this up - here are the specs on our "NITTO" R34 GT-R:

STANDARD RB26DETT bottom end

ARP headstuds

Nitto Headgasket

Standard oil pump

Custom head by Mercury Motorsport

6Boost mani

Precision 7675BB turbo

Twin Precision wastegates

4" exhaust custom made

Haltech Platinum Pro ECU etc.

Upgraded fuel system

Splitfire coils

100mm thick FMIC

Custom i/c piping

OS Giken sequential gearbox

Power: 622awkw/845awhp @ 43psi (ran in 5th gear, to keep the 1:1 ratio due to gear changes, 6 straps holding it down)

Here is the vid:

Link to comment
https://www.sau.com.au/forums/topic/411489-500kw-club/#findComment-6649687
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...