Jump to content
SAU Community

Recommended Posts

yea lota quick'ish 2nd hand euros for <100k m3 m5 c63 e63 rs4 s5 etc

Haven't seen any c63 that cheap 110k If ur lucky and n5s have like 100kms on em which is way to much

M3s best value

Or isf they are like 80k cheap for what it is

iirc the 370 can smoke a m1 as per top gear tested

370?

Haven't seen any c63 that cheap 110k If ur lucky and n5s have like 100kms on em which is way to much

M3s best value

Or isf they are like 80k cheap for what it is

there are c63s on carsales with ~30ks for just under 100k even cheaper for m5s with similar ks...

we're still getting ripped big time here considering low mileage m5s in the UK sell for like 15-20k pounds

I usually have a candle burning when I change my fuel filter. Need light yo.

Luxury...

I have to create my source of light using an angle grinder on scraps of metal.

Wow just saw an S15 pulled over on Eastlink...by a dirtbike/motard with red and blues flashing...if that was a cop he wasn't wearing a uniform either. Bonnet was open...

370?

there are c63s on carsales with ~30ks for just under 100k even cheaper for m5s with similar ks...

we're still getting ripped big time here considering low mileage m5s in the UK sell for like 15-20k pounds

370z

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...