Jump to content
SAU Community

Recommended Posts

fkn too hot today...

my car alarm speaker died.

just started going off at full volume, didn't respond to the remote, open bonnet (loud as an air raid siren in a small concrete room) use the key, still no response.

WILL NOT TURN OFF

so of course I did the only manly thing possible and ripped it out.

once in my had it started popping and cracking. dropped it on the ground and it made a few big explodey type noises.

riiiiiiiiiiiiiiiiiiiiiiiiiiight

so i still have an immobiliser but no sounds :/

Sounds like a battery backup battery melting down and shorting out and exploding with the heat...

lern2flavour fgt

salt and caramel is like popeye and spinach

Nah it's garbage. Well aware of it's etymology but doesn't stop one from spoiling the other. Caramel stands on it's own.

ice cream is only really needed for milkshakes if you dont have coconut cream.

zooper doopers all da way mang

changed oil, filter and fuel filter after work so havent got much left to do tonight except pack tools. so will go to christmas light spectating to run oil in a bit.

ice cream is only really needed for milkshakes if you dont have coconut cream.

zooper doopers all da way mang

changed oil, filter and fuel filter after work so havent got much left to do tonight except pack tools. so will go to christmas light spectating to run oil in a bit.

Haha see ya there!

You do need a few km' for dat 1000km aye

nutsaboutchocolate2L.jpg

/thread

and when you are almost done with the tub bowl, the melted icecream at the bottom hides choclaty nutty goodness. I need to get me some asap

ice cream is only really needed for milkshakes if you dont have coconut cream.

da fuq? people put coconut cream in milkshakes?

I went back to the old theme and it was all good... But nooooooooooo the forum has to be smart and bring me back to this shit.

Stop f**king updating the f**king forum Christian f**k!

ice cream is only really needed for milkshakes if you dont have coconut cream.

zooper doopers all da way mang

changed oil, filter and fuel filter after work so havent got much left to do tonight except pack tools. so will go to christmas light spectating to run oil in a bit.

stripped the sump plug on the Honda...cant change oil :/ cant find vice grips to undo plug...f*k it all...

wheres Aaron

i got him a pressie.....

996772_672611916092708_711109815_n_zpsba

and when you are almost done with the tub bowl, the melted icecream at the bottom hides choclaty nutty goodness. I need to get me some asap

da fuq? people put coconut cream in milkshakes?

Seriously try it, you'll never look back.

other day did real passionfruit pulp, coconut cream, milk, ice. blend. good stuff. blueberries go the best though/

stripped the sump plug on the Honda...cant change oil :/ cant find vice grips to undo plug...f*k it all...

damn... i snapped an aluminium sump plug on the car today, luckily it screwed out and there was another one lying around.

like white chocolate occasionally, but dark chocolate hits the spot for me (not over 75% though)

damn... i snapped an aluminium sump plug on the car today, luckily it screwed out and there was another one lying around.

well , i guess you win the who f**ked the sump plug the most game :rofl:

I knew this one was f**ked...has been for years but i always remembered as long as I used the right ring spanner it was ok...stupid me put a socket on it...that was the straw that broke the camels sump plug

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
×
×
  • Create New...