Jump to content
SAU Community

Recommended Posts

Youre putting way too much effort in for a "budget job".

Guy isnt even going to notice the difference between the minor ones only you can see

its for my vanity :P

its just a really nice colour to work with...

btw i have a surprise for you...;)

Well yeah, I don't think he is gonna plumb it back for now (re: screamer).

How he is going to fit that into the 5in cat, I do not know. Unless he runs it direct to the body of the cat itself. I believe ARTZ had that done.

But my car cannot be made to 'look very sweet' by the efforts of one man alone.

It will most likely require the efforts of three men, namely scotty, artz, and aaron by the way of his guard roller and general "greg don't do stupid shit" advice.

is Scotty stealing my ideas again :whistling:

yes i run wastegate into side of cat....(well what looked like a cat)....2 pipe enter....1 pipe leave....works well..

i still haven't made it down to get your bumper either...as Lee said spending way too much time on red car....does look sexeh tho so its worth it...

hahah. im joking.

after the mani scotty had fuark all to do on mine. dump will take 1-2 hours.... cooler piping the same... i just need to get over and get the work done....

i literally worked for about 2 hours yesterday and didnt bug him once. i was proud.

hahah. im joking.

after the mani scotty had fuark all to do on mine. dump will take 1-2 hours.... cooler piping the same... i just need to get over and get the work done....

i literally worked for about 2 hours yesterday and didnt bug him once. i was proud.

is that because he charges by the hour and you dont want to pay him for socializing

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...