Jump to content
SAU Community

Recommended Posts

ah cos its absolute pressure

ie at idle or sea level pressure is 14psi or 100kpa already

so pressure is 262kpa, minus 100kpa

gives run time boost at 4800rpm

162kpa, gives 23PSI, geez

i wonder if thats right, thats from the vipec map sensor

the eboost one doesnt show that high

hmmmm

yeah not sure on the "statistics" page

some of them make sense, some are really way off

ie # of times started and run time in minutes seems reasonable

but then you look at peak ECU temp, 13000deg celcius???

max intake temp 12,000 deg

max volage 184

probably worth clearing them

but then kinda dont wanna clear the # of times started and minutes

Why, they are unrealistic too...

Started 36,000 times...that's 10 times a day everyday for 10 years and average 1 minute per run. Unless granny drove it to regularly and compulsively check for mail at the end of her driveway, or it had some serious starting issues, I call bullshit.

yeah the max temps and max #s are really really wrong

but the run time in mins and started sound somewhat believeable

i plan on keeping the car so ill probably erase the stats back to zero

cos it would be kinda handy to have some of the top scores over time

but currently theyre all whacko

cos it tracks # of times you hit limiter, #s injectors max, total knock etc

but currently they're all mega high

post-2054-0-32876300-1402125313_thumb.jpg

I felt an accomplishment driving into Bayswater @ Import monster and leaving without a defect today

fark that's lucky as! i heard pettit was hosting a defect shop near barry st bayswater today :s

nasty

whats the defect for

height below 100mm, pod filter unsecured pod filter and exhaust doesn't comply with noise standards. also have to provide a rwc. fun times :/

Luck of the draw mate, eastern burbs just increases the odds

true that :( booze bus turned into defect station.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok I get you. But isn’t the butterfly intake a headache with the +T?  see this is my plan so far but please advise me into the right direction.  Nistune Ecu, 1000cc Bosch injectors, TD05 or TD06 Kinugawa turbo using stock rb25det exhuast manifold, walbro fuel pump unsure of model I think it’s 450/460, spitfire coils and sparks to suit and a R35 MAF sensor and boost sensor.    I was thinking maybe do a cheap eBay plenum $400-500 or try find a stock det neo intake. I think I’d port match it so it’s getting the full capacity but open to advice please.  Thanks 
    • The issue now is the 'fuel cut' while driving, and when it happend, it does not stall. This, I did not test the fuel pressure while driving as I cannot with a fuel pressure gauge. I do have Nistune logs, yes. I have also replaced the MAF Sensor.   Also related to the FPG Fuel Hanger – I just realized that I need a Deutsch Crimp Tool to crimp some cables for the FPG Fuel Hanger. Need to purchase additional cables as the kit only included 2, which are for the float. FPG has not responded to my emails so far since purchasing. I thought about taking it to someone and having it done professionally, but I am reluctant since everyone I took it to messed up in some way.  
    • There's a good German place in Brisbane if youre up for the drive 😛
    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
×
×
  • Create New...