Jump to content
SAU Community

Recommended Posts

Man if it wasn't for rego, the number of vehicles I would own...

Should be able to pay one registration for multiple registrations, not like you can use them all at once anyway. Registration for a driver rather than the vehicle,

  • Like 2

Man if it wasn't for rego, the number of vehicles I would own...

Should be able to pay one registration for multiple registrations, not like you can use them all at once anyway. Registration for a driver rather than the vehicle,

Then they'd get complaints from all the "Aussie Battlers" who can only afford one car for the whole family, but have to pay heaps for a yearly drivers licence for 2-3 people to drive it.

Better for the economy (when we had local production) and environment and safety to keep old bombs heading towards the wreckers...

Then they'd get complaints from all the "Aussie Battlers" who can only afford one car for the whole family, but have to pay heaps for a yearly drivers licence for 2-3 people to drive it.

Better for the economy (when we had local production) and environment and safety to keep old bombs heading towards the wreckers...

Then give the option of a multi vehicle drivers licence / rego that is more expensive but not ludicrous, like the $3000 a year for 4 vehicles that it costs now.

Or weekend rego similar to club rego but car still needs to be roadworthied.

Anyone regret selling a car and wish they could have it back?

Like, would pay now what they sold it for to get it back?

Most of them were trashed by the next owners, so no..

Except maybe my starion, that went to an major enthusiast and might have been restored, so yes, I'd pay $900 to get that back if it was restored

In my head I keep going over a forged engine and a big top mount and making it a track bitch, but would need to get another daily first :(

Just do somewhat basic forged engine, bug lowmount and keep it bothable ;)

3076R Low doesn't look TOOOOO different to a stock turbo ;) Considering I'm without a heatshield at the moment anyway. Dat noise tho, pppsssssssss

Edit: Hmmmm, what do they make on E85? 330rwkw?

desire to modify evo = searching for reasons to keep it.

I agree with this sometimes in the case of boredom, but now that my car is where I want it modification wise, I have no desire to modify further but still want to keep it.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...