Jump to content
SAU Community

Recommended Posts

Up for sale is my r32 gtr ( r32,4 gtr ) needs some love and attention:

the fibre glass wide body kit has stress cracks in some spots. will be sold with space saver wheels. will need to be towed.

car is also runing stock ecu ( it will start,but its rough due to not liking having no afm and running 800cc injectors) for the time being while the vipec ecu gets checked over as car wouldnt start with it. possible damage to the board from hooking up battery wrong way,

engine possibly needs a new head gasket and/or valves cleaned for sitting for a long time. has low compression on 2 of the cylinders due most likely to those reasons.

as for the good bits, Interior is in good condition,shouldn't take much to get it going.

Would suit someone who knows what they're doing or has a budget to get it running and looking good.

will look awesome with some TLC

Also just put in new NGK BCPR7ES spark plugs, new Optima Yellow D51R-T1 battery and a new POD filter.

probably alot of other mods i don't know about

would make an awesome track/drift car

car is full of potential in the right hands. my knowledge of cars was my let down but someone with more knowledge could make this car shine and become a beast of a GTR

Car has 117,502 kms . car has no been driven in a few years

Engine:

RB26
T04R Single Turbo kit
Stainless Manifold,
60mm Tial Wastegate
Tomei 260 Poncams
Tomei adjustable cam gears
Sard 800cc Injectors
Sard 280ltr Fuel Pump.
Gates timing belt.
R33 oil pump
Braided fuel lines.
Management:

Vipec ECU

as well as stock R32 ECU
Suspension:
Tein Mono-flex fully adjustable coilovers
Cusco rear strut brace
Driveline:
Stock 5 speed
Exedy triple plate clutch
Nismo short shifter
Brakes:
R33 GTR Brembos calipers all round.
DBA slotted rotors.
R33 GTR ABS unit.
Wheels:
space saver wheels (lol)
Interior:
Recaro SR reclinable drivers seat.
Jaycar speakers all round
Nismo 260km Cluster
2/4wd Switch.
Turbo timer
Viper Alarm
EXHAUST:
4" Veilside exhaust from Turbo back. With 2 centre mufflers (quiet)
Exterior:
Customised Full genuine Bee-R (B324r) Widebodykit with R34 gtr front end.
R34 Xenon headlights
Sparco alloy fuel cap.

post-14097-0-11352500-1446196425_thumb.jpgpost-14097-0-48395100-1446196541_thumb.jpgpost-14097-0-18371700-1446196551_thumb.jpgpost-14097-0-63155500-1446196560_thumb.jpgpost-14097-0-07759100-1446196592_thumb.jpgpost-14097-0-54672600-1446196601_thumb.jpg

what the car used to look like before previous owner painted Matte Black

post-14097-0-32123900-1446196639_thumb.jpg

$8,000 ONO

Edited by deprived777
Link to comment
https://www.sau.com.au/forums/topic/460690-r324-gtr-victoria/
Share on other sites

PRICE DROP: $7,000 dropping price due to realising car will need some money put in it to get it perfect. if someone parted this out they would quite easily make profit. i just don't have the time,knowledge or patience to do it myself. Or invest time and money into it and have an awesome looking car that will turn heads. i've never seen another car like this on the roads personally

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...