Jump to content
SAU Community

Recommended Posts

Quote

Well, from my experience, running a Skyline costs an arm and a leg, especially if you track it. And mine's not even a GT-R...

Ah geez, don't tell me that... :D

Oh well, never mind. I'll just tell my wife I didn't know it would cost so much... again.

Quote

35 sound really underwhelming

I kinda like the way the R35's sound with a nice exhaust. That have a kind of growl about them that sounds cool.

  • 2 weeks later...
On 28/10/2016 at 4:43 PM, LSX-438 said:

GTR does not make a great daily drive car.  Unless you are going to track it, i wouldnt bother

Says who? I daily drove my GTR for a few weeks. Was awesome. Members of the club use them for work and daily drive them as well. i got a work car now so no need to daily mine.

On 11/11/2016 at 1:08 PM, BLISTC said:

Says who? I daily drove my GTR for a few weeks. Was awesome. Members of the club use them for work and daily drive them as well. i got a work car now so no need to daily mine.

Says me. Just my opinion.  I daily drive mine for 2 years.  And i tracked it, hard.

  • Like 1

I think you might both be talking about different models.

Either way, a lot of the "issues" people have with GTRs, of any year, is cost, and what's expensive for one is not for another, it's all relative. 

 

On ‎1‎/‎11‎/‎2016 at 10:38 PM, tridentt150v said:

Sell the lot..........blow it on booze, ice, and hookers!!!

Personally an R35 is a dream.......affordable, but excessive.  Lots of us could afford one if we were of single purpose, but our practical nature takes over and we buy a station wagon, Commodore, falcon, camry, Twin cab 4wd and house etc.  And then have an earlier model Skyline as our weekender.  Driving an R35 would send me to the grave worrying about shopping trolleys, drunk drivers, P Platers, sticky fingered kids, not to mention car thieves and jealous types who just want to trash the rich!!!!  I could never leave it in the Westfield car park while I had coffee with friends.

Lol, none of our cars are even actually transport, you can't leave them anywhere

  • 1 month later...

I just bought my R35 (2014) to daily drive it and if cars are you life then why not. Luckily I get a car allowance of $15k and it almost pays for everything including the loan because I took it out of my home loan @ 3.8%pa, as long as I don't drive it hard or track it! But no doubt I will!!! I'm only planing on keeping it for about a year so it shouldn't depreciate to much.

Anyway do your research as I did and you'll find the the 2011 and older R35s could be a risk with transmission issues.

Just remember everything is expensive.
Tyres $3k and last 10000-20000kms
5000km services $800
30000km services $2800
Fuel will be between 15-30L per 100km

If it ends up costing to much you can always just sell it. There's about 5 that sell every week on car sales so people are buying them!

16 minutes ago, PureGTR said:

I just bought my R35 (2014) to daily drive it and if cars are you life then why not. Luckily I get a car allowance of $15k and it almost pays for everything including the loan because I took it out of my home loan @ 3.8%pa, as long as I don't drive it hard or track it! But no doubt I will!!! I'm only planing on keeping it for about a year so it shouldn't depreciate to much.

Anyway do your research as I did and you'll find the the 2011 and older R35s could be a risk with transmission issues.

Just remember everything is expensive.
Tyres $3k and last 10000-20000kms
5000km services $800
30000km services $2800
Fuel will be between 15-30L per 100km

If it ends up costing to much you can always just sell it. There's about 5 that sell every week on car sales so people are buying them!
 

OP mentioned a 50K a year income, and ontop of that a 30K loan. Not a very wise financial decision at all. You would have no social life or disposable income after what would most likely be a $500+ monthly loan repayment

Plus other expenses - clothes/mobile phone/petrol/food/ etc etc

Rego is 1K a year

Insurance would be 3K + a year

Do the maths and it's simply a bad idea.

Edited by djvoodoo
  • 2 weeks later...
On 26/12/2016 at 6:20 PM, BakemonoRicer said:

Get a Silvia

its the poor mans GTR and with light mods will leave a GTR for dead around a track

i mean heck, an S15 can be had for 10-15k now....its a slept on classic

LMAO

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Place the new daughterboard in the case and mount it using the 3 small black rivets provided, and reconnect the 3 factory ribbon cables to the new board Then, use the 3 piggyback cables from the daughterboard into the factory board on top (there are stand offs in the case to keep them apart. and remember to reconnect the antenna and rear cover fan wires. 1 screw to hold the motherboard in place. Before closing the case, make a hole in the sticker covering a hole in the case and run the cable for the android unit into the plug there. The video forgot this step, so did I, so will you probably. Then redo the 4 screws on back, 2 each top and bottom, 3 each side and put the 2 brackets back on.....all ready to go and not that tricky really.      
    • Onto the android unit. You need to remove the top screen because there is a daughterboard to put inside the case. Each side vent pops out from clips; start at the bottom and carefully remove upwards (use a trim remover tool to avoid breaking anything). Then the lower screen and controls come out, 4 screws, a couple of clips (including 3 flimsy ones at the top) and 3 plugs on the rear. Then the upper screen, 4 screws and a bunch of plugs and she is out. From there, remove the mounting brackets (2 screws each), 4 screws on the rear, 2 screws top and bottom and 3 screws holding in the small plates on each side. When you remove the back cover (tight fit), watch out for the power cable for the fan, I removed it so I could put the back aside. The mainboard is held in by 1 screw in the middle, 1 aerial at the top and 3 ribbon cables. If you've ever done any laptop stuff the ribbon cables are OK to work with, just pop up the retainer and they slide out. If you are not familiar just grab a 12 year old from an iphone factory, they will know how it works The case should now look like this:
    • Switching the console was tricky. First there were 6 screws to remove, and also the little adapter loom and its screws had to come out. Also don't forget to remove the 2 screws holding the central locking receiver. Then there are 4 clips on either side....these were very tight in this case and needed careful persuading with a long flat screw driver....some force required but not enough to break them...this was probably the fiddliest part of the whole job. In my case I needed both the wiring loom and the central locking receiver module to swap across to the new one. That was it for the console, so "assembly is the reverse of disassembly"
    • But first....while I was there, I also swapped across the centre console box for the other style where the AV inputs don't intrude into the (very limited !) space.  Part# was 96926-4GA0A, 284H3-4GA0B, 284H3-4GA0A. (I've already swapped the top 12v socket for a USB bulkhead in this pic, it fit the hole without modification:) Comparison of the 2: Basically to do the console you need to remove the DS and PS side console trim (they slide up and back, held in by clips only) Then remove the back half of the console top trim with the cupholders, pops up, all clips again but be careful at the front as it is pretty flimsy. Then slide the shifter boot down, remove the spring clip, loose it forever somewhere in the car the pull the shift knob off. Remove the tiny plastic piece on DS near "P" and use something thin and long (most screwdrivers won't fit) to push down the interlock and put the shifter down in D for space. There is one screw at the front, then the shifter surround and ashtray lift up. There are 3 or 4 plugs underneath and it is off. Next is the rear cover of the centre console; you need to open the console lid, pop off the trim covering the lid hinge and undo the 2rd screw from the driver's side (the rest all need to come out later so you can do them all now and remove the lid) Then the rear cover unclips (6 clips), start at the top with a trim tool pulling backwards. Once it is off there are 2 screws facing rearwards to remove (need a short phillips for these) and you are done with the rear of the console. There are 4 plugs at the A/V box to unclip Then there are 2 screws at the front of the console, and 2 clips (pull up and back) and the console will come out.
    • So, a bit of a side trip, but one that might be interesting for people with JDM cars and japanese head units. I know @Pac previously posted about a carplay/android auto adapter he installed which used the AUX input, and @V35_Paul put in one of the Tesla style units that replace both screens. The option I went with was a Lsait LLT-YF-VER5.87_2 (https://www.alibaba.com/product-detail/Lsailt-8GB-Android-Multimedia-Interface-for_1601187633672.html). Price was $1,150 for a single unit although they are much cheaper if you are willing to buy 2....$857ea. Make you you get the version 2 not version 1, it is faster and has a better UI - this is the manufacturer listing: http://www.lsailt.com/product/348.html. BTW if you've never bought from Alibaba before, don't be concerned....these guys can't stay in business unless they are responsive, ship fast etc, they were excellent (probably faster shipping than most local places) So, this was my task for a lazy Sat afternoon....looks complex but was all done in a few hours (it probably helps that I had some of it apart before so it was a bit familiar). I also decided to add a HD USB drive recorded at the same time and the unit also supports an aftermarket reverse cam (if you don't want to retain factory) and also AV in and HDMI out It looks much worse than it is, in fact in was genuinely all plug and play (no custom wiring at all). This video was pretty good (skipped a few steps), unfortunately they are an Aussie seller but no longer sell this unit (I guess Carplay/AA adapters are easier to install and much cheaper) https://www.youtube.com/watch?v=T5hJfYOB8Dg
×
×
  • Create New...