Jump to content
SAU Community

Recommended Posts

No worries, still keen to see what you can come up with for the little motor, BTW that R32GTS-t I offered you has since been sold.

Edited by Missileman
  • 2 weeks later...

Further developments. This is a Ceramic ball bearing ATR43G3SAT turbo that no longer require water cooling. Video shown turbo shaft rotation on RB25det Neo motor with engine start and shut. Super responsive.

Does that mean that you will need to idle down the car like an old truck after each drive?

Water and oil cooling has many benefits, unless the CBB is different

Just works like a normal water cooled bb unit. Except it doesnt require water cooling. Made for cars with oil cooled only turbo setups.

I will withdrawn the comment for now. It could be other causes, The bov is blowing air out, not sucking in.

You can run water to it if you want to.

Previous data shown boost curve is almost identical. but this one made more power.

Using same car with identical mods:

21U G3 high flow:

boost.jpg

ATR43G3SAT CBB

boost.JPG

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...