Jump to content
SAU Community

Recommended Posts

I wonder where is that socket now...

I borrowed yours, lost it somewhere, searched for ages... drove to total tools and bought another, then on the drive home from total tools found yours under the front seat of my dads car when I was braking and it rolled out. :P

Sitting in the top of my toolbox, do you need it for your.. o w8 no car :P

Cheeky kunt.

I borrowed yours, lost it somewhere, searched for ages... drove to total tools and bought another, then on the drive home from total tools found yours under the front seat of my dads car when I was braking and it rolled out. :P

Why is it in your dads car?

12hour work days, 5am wake ups something to get used to...

Pretty fun so far, been driving around in Tonka trucks and had to put out a massive fire for fire safety training.

6 fire extinguishers couldn't put it out. Had to use the fire hose haha

Should just borrow Grants 36mm for doing CV nuts, it's what everyone else does :P

it turned out to be 26mm, i have a socket of that size but it would have had to be a deep socket and i dont have one of them in 26mm

all good now, removed and packed up to be shipped to sydney tomorrow. all aboard the im poor train!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...