Jump to content
SAU Community

Recommended Posts

nah man the drive back, as soon as we got out of shep it came down hard.
i was cruising at 70, eventually crept up to 90 and then at one point when it dried a little we were all hiking it at a considerable speed lol, then it came down again.
lucky we all got home or else ash would have to be like "rip sau club member 335932. one like = one respect"

  • Like 1

i remember the soarer window falling into the door and not coming up.

man, what a shit car it was.

I remember racing your soarer. On that private road on the way back. I think Jonoe was your passenger

had a mate who knows what hes doing when it comes to wiring come and help tuck the headlight wires, relocate the front body harness.

f**k me.

nissan really couldnt be f**ked with these cars..

Because it's non value adding to the customer. No Joe Shmoe is going to pay extra for a wire tuck/clean engine bay.
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Started sifting thru my brakes to decide which ones I will run on Clem   Made me think I should just put them all on Silver...for when brake fade just isn't an option   Should be able to bump rotor up from 343x32 to 348x36 off Supra. Not sure if the Supra annulus is right for the Alcons or APs but trying g to find a used Supra\M4 rotor to test fit The Alcons seem to gain 1-2mm clearance which all helps  
    • So car is getting a few mods to the cage and some jacking points welded in Meantime Ol Silver gets a new gearbox and shiny clutch.  Old Box is being set aside for Clem  
    • Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
    • Thanks Fella’s   to take this off topic and to elaborate a bit more. I have an rb25/30 going into a r32 GTST.. expected to make around 600-700hp. Would you?   A) R34 GTT box   B) CD00#?  I’ve seen a few posts about the CD swap and sounds fairly involved with making it fit etc but if it’s worth the work then I’ll go that way
    • Lower at the hubs. Funny I forgot to mention that part. Do this pull here I turned the camera off too soon but the graph shows a drop at the top and that was because the pipe from the turbo blew off. The tuner said we could’ve made possibly another 15 whp. He also added if I switched to ethanol we could up the boost some more as well. I was comfortable capping it at the most of 20 pounds. Turns out the turbo pipe just needed a new worm clamp. Got home replaced that then did a third gear pull from 3k to 7200 rpm and the power was great to the top. I just got an ecu mounting bracket from IEE that I need to try and get everything to fit well. It’s a PITA to get the harness and ecu fit properly behind that kick plate 
×
×
  • Create New...