Jump to content
SAU Community

Recommended Posts

  • 2 months later...

What is the highest recorded "realistic" figure being pushed on RB using -5/2530/-10/RS - 0.64 hot sides?

This is my car on -5's, E85, built 2.6 with all supporting mods.

Going 2863's as Garrett sells them with my old rear housings in the new year, hope to see improvement everywhere.

post-44791-14521558417031_thumb.jpgpost-44791-1452156320792_thumb.jpg

Edited by Wesley James R32GTR

Are people not getting harassed by police after they see a big single slapped on the side of the engine?

The way I see it I'd rather have as much as possible and hidden away rather then eek out an extra 200~300hp crack the gate once get pulled over and defected then put it back to stock to pass it all.

Been there before its a massive head f**k!

Or are the popo a little more relaxed these days, just curious?

every 20min something with a gate is screaming past my house :)

Edited by mr skidz

No need for homo gate rubbish. Plumb it back :yes:

Don't be jelly, you love gate deep down inside like how you love big singles 7 years ago and it took you till now to come out of the closet :)

  • Like 1

I don't like the tone of screamer pipes, much prefer the tone and sound of it coming out of an exhaust.
speaking of gates, I should probably get some 15psi garrett actuators for my turbos instead of using the 10psi tomei ones shouldn't i?...

I don't like the tone of screamer pipes, much prefer the tone and sound of it coming out of an exhaust.

speaking of gates, I should probably get some 15psi garrett actuators for my turbos instead of using the 10psi tomei ones shouldn't i?...

rule of thumb (for myself that is) 75% or so of your targeted max. desired boost.. so say you want to run 2 bar, get 1.5 bar actuators or so.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Just a thought, was that car and auto at any point of its life? If so, maybe whoever bridged the inhibitor switch/circuit did a not so good job.
    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
×
×
  • Create New...