Jump to content
SAU Community

Recommended Posts

I've tried my hardest but i don't have a trailer or a car with a tow hook. Ive also had no luck finding someone i know that has one. The renting path is also not going to work just becuase of how early I need to leave.

So, what happens if something happens to my car and i can't drive it back up to melbourne? Is there an sau club trailer or can anyone recommend a towing company as a last case scenario?

  • Replies 280
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

To the guys looking at the RS3's.

I got my set for tad over $880 deliverd from tirereack.com. 255/40/17

Couldnt fond them for less than 1100 locally......maybe there is somewhere but thats the best i could do.

They do feel very soft. But they only just made it on the car so havent actually driven on them yet.

Ive had KU36 and RSR's so it will be interesting to see how they compare.

Fingers crossed for some good weather. Good being cold, windy and cloudy....but no rain!!

Cheers,

Dave

Hi Dave,

Will be good to see what you think of them.

What times have you done on KUs / RSRs and what tracks?

Also what car?

Will be good to get a comparison from another user of the KU / RSR.

Hey Femmo,

Its a 33 GTST.

Its had some changes as time has gone on so hard to directly compare.

The RSR's where about 1-2 seconds quicker around winton than the KU36's but they go off after 1 lap!

Maybe its the weight of the car but i never did a warm up....just cruised around for the out lap and then did one timed lap. Although this was during the warmer months.

Looking at my times i get slower after that first timed lap, and you can feel the under steer getting out of control.

I think my best is a 1:41.X on KU's and a 1:40 dead on RSR's.

To be honest i only ran the KU36's for one track day as i didnt like them at all. They were progressive but also went off really fast.

But they where cheap so i suppose its a compromise.

Looking forward to the RS3's. Ive also got more rubber on the front this time so again will be hard to compare directly.

Cheers,

Dave

Car came back with 260 at the treads. Not bad considering it's a tiny 21U housing.

Gah, have to wait 4 days though. 4 painful days!

damn i'm lagging behind

oh well next 18 months is just for shits and giggles anyhow

damn i'm lagging behind

oh well next 18 months is just for shits and giggles anyhow

I would have liked a little more up top, but I suppose that is the limit of the small housing. The larger OP6 housing maybe an option down the track, but WILL require larger rear tyres for sure.

Maybe WTAC 2013 with 280-290rwkw and 285 rears.

I'm up for a garage and in group 2.

no red bus for Katie to keep warm in this time!

I think you can only fit 2 cars.

Do you have to call and book in advance like sandown?

You can call and book.

They only fit 2 cars.

Dave I saw your car in at Tyrepower yesterday getting the O3G's fitted. Much excitement.

Changed the rear tie rods last night....fark it's the bloody HICAS ball joint that has movement, FU Nissan!

The pain the follows removing that SOB with be heavy on the beers.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...