Jump to content
SAU Community

Recommended Posts

you can also use a Power FC and run E-flex, my car for example does and I havnt had any problems with it,

So you have a flex fuel sensor hanging off it or is it set up for E85 only?

So you have a flex fuel sensor hanging off it or is it set up for E85 only?

its setup for Eflex only, My tuner tuned the car last winter and told me to keep an eye on the Knock levels on the power fc. Both in summer and winter there has been no issues with knock so the blend must be fairly consistant, ive had a car full of people and 1.5bar in third with no more than 20 showing up on the power fc, So im assuming that the tune is very safe and not on a knife edge so as to compensate for any differences at the pump.

the Caltex fuel stations are within 30mins and I can fill some 20L containers too

Edited by AngryRBGTX

Adaptronic has a good ecu, haven't had issues with mine and it supports e85

Andy at adaptronic was a really big help with the first set up and when it comes to upgrading somewhere I just get on there site and upgrade the software on my laptop and on from there. Just another option ;)

I just got my gtr tuned at allstar,

on 98 with -7 turbos at only 16psi,

got 378hp at treads,

car runs very very smooth, and hardly feel the boost come in, the power curve is perfict,

so far im very happy with the work, once I get a fuel reg/z32 air flow meters, and a elec boost controller il be taking it back for 20psi,

  • Like 1

Adaptronic has a good ecu, haven't had issues with mine and it supports e85

Andy at adaptronic was a really big help with the first set up and when it comes to upgrading somewhere I just get on there site and upgrade the software on my laptop and on from there. Just another option ;)

Are you using the e1280s?

I just got my gtr tuned at allstar,

on 98 with -7 turbos at only 16psi,

got 378hp at treads,

car runs very very smooth, and hardly feel the boost come in, the power curve is perfict,

so far im very happy with the work, once I get a fuel reg/z32 air flow meters, and a elec boost controller il be taking it back for 20psi,

Heard a few good reports from them now, which is promising. Hopefully ill be another happy customer once i see Richard in a week or so

I tow my car 1000km on a trailer just get Mark at Godzilla to tune my car and Derens workmanship is some of the best I've seen aswell.

Couldn't speak highly enough of the place!

that's good to hear then. Yeah they are only just around the corner from my place so thought i'd check them out. Thats dedication towing your car 1000km though wow haha!

post-98689-13719815606289_thumb.jpg strongly recommend Horsepower solutions this is my low boost setting of 16.5 going for high boost soon running 98 with octane very happy.

Justin is the guy you want to speak with

Edited by Cyifly

i've moved to brissy a few months ago and in need of getting my car tuned (R32 GTR V spec, still running stock boost/stock tune) so thanks for the suggestions, its good to hear that there are a number of very promising options around.

Just my two cents - I personally went with Carlos from Millennium Motorsport. After we finished the build, completed a safe road and ensured the car was right for the dyno I took it to him. He had the car tuned in one day but opted to keep it for a few to sort out the cold start accurately. His customer service was professional and anything that was needed to be explained was done so in person. Very genuine guy.

Results - 402.6rwhp @ only 15psi (on pump 98) and the car drives like a dream. Car wanted to keep making power but we agreed to keep it safe (being stock bottom end).

Edited by Reflector
  • 2 weeks later...

hey guys, is EFI performance still going and if so are they still the nistune pros?

Yes they are still going, they have moved to Southport.

They still offer their service for Nistune.

We have been in discussion with them recently and they are still offering 10% discount for SAUQLD Club members on presentation of your club card.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...