Jump to content
SAU Community

Recommended Posts

Flat tyre yesterday... Nail goes in, Nail comes out... big hole and dropping 10psi in 2 minutes. Was running on the sidewall for a few km's, and it was only feeling mildly sloppy on the road... pulling slightly to the left. Only realised something was properly wrong when I booted it hard from the lights and the rear end started walking to the side.

Liam came and rescued me with a socket set and breaker bar, because top bloke.

  • Like 1

The tree is HUGE. Cutting it down will be a full day with people in the air with chainsaws and it goes across 3 properties.

The council here LOVE fining people for cutting them down.

Guy up the road got dobbed in by some nosey f**ker and the council were there handing out fines before the tree was even down.

That would make sense but I was actually ahead from the get go. Maybe shit reaction time from him but AD08Rs are great at launching.

He did show me his launch at the next lights and it moved but not impressively so. Seen GTRs move quicker off the line.

When you do your fast and the furious antics on this street, how far do you go? Are we talking 0-60 here or full quarter miles at a time?

Just curious as to what interval to live my life by

  • Like 1

When you do your fast and the furious antics on this street, how far do you go? Are we talking 0-60 here or full quarter miles at a time?

Just curious as to what interval to live my life by

Woah woah...not the street, this is Calder Park baby...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
×
×
  • Create New...