Jump to content
SAU Community

Recommended Posts

Quote from RBA Governor Glenn Stevens

"I think the assumption that there's an easy road to riches through leveraged holdings of real estate, it strikes me that however much that may have succeeded for some in the past, that is not a great strategy and prices can fall. They have fallen. I think while I've been in this job we've seen them fall two or three times."

Well... this is the current state of the passenger front rotor, it started making a bit of noise so a few weeks later I eventually decided to change the pads and rotors.

Who can spot the issue?

1JSWuhR.jpg

The main issue is.... This is a slotted rotor.

5 x 114.3, same as the Skyrine.

Pat, I would offer to let you take mine for a spin, but the rego on it expires today.

The main issue is.... This is a slotted rotor.

5 x 114.3, same as the Skyrine.

Pat, I would offer to let you take mine for a spin, but the rego on it expires today.

* was

Still, it'll never cease to amaze me the knee jerk mentality of the share market...the announcement was nothing we weren't expecting already and yet it pulls the share out of a slow and steady slide. In fact, wouldn't surprise me if it ends up even again by the end of the day.

The worst part is you drove mine beforehand, from memory, and decided you needed more lag

Nah, it was because Trent thought there was a suspicion that there was an issue with back pressure with my old ss2 turbo. Ended up being the CAS but i cbf spending anymore time on the car to put on a smaller turbo and retune.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...