Jump to content
SAU Community

Recommended Posts

  • 8 months later...

We took the car to the track. The car got stuck in safety boost some how. Also ended up killing the front diff. Customer does not want to go back to the track yet and risk hurting the car again.

 

Edited by Jc052685

"there will never be a trap speed shared."

So I win $50?

Don't stress though, as this is the reverse situation where your number is actually smaller and it's a good thing. $50AUD is like $3.50 USD these days ;)

 

  • 3 years later...
18 hours ago, Torque Curve said:

Has there been any good modern setups with twins lately??

 

So far the only "modern" twins setup that I've seen which has generated a result which gets one thinking is the PMC/Integrated Motorsport R34 GT-R which makes >1100hp @ crank on G25 660s.  It's laggy as hell, but has a wide (like 6000-10000rpm?) power delivery so there is a bit of a swings and roundabouts thing going on there - you would NOT use that for what most are looking for with twins, not least because it's not stock location but instead some wild fabrication involved.  I don't expect there to be any major development with stock location twins as turbo tech isn't really the primary hold up, it's mainly packaging limitations imho... which is a lot of why I'm so pro-single on an RB.


BTW, this thread is hilarious to look back over.

  • Haha 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...