Jump to content
SAU Community

Recommended Posts

Alright forum gods, i need your help again. RB26 just recently started making this very light tapping/knocking noise in the engine. It almost sounds like a bunch of marbles being tossed together. It just recently started happening or i might be going crazy because i didn't notice it before. It happens at idle, SOMETIMES. But it goes away the more i rev the engine. I'm not sure if i can't hear it because of my exhaust or if it actually goes away, but the sound DOSENT get louder the harder i drive it. In fact, the more gas i give it, it typically goes away but will occasionally come back. 

I did some research and i think it could be the lifters, i dont know too much about them besides that they help the valve open and close. Any remedy to this? And i'm i still safe to drive with it in the mean time? The weather is great now. 

 

46 minutes ago, kevboost7 said:

Alright forum gods, i need your help again. RB26 just recently started making this very light tapping/knocking noise in the engine. It almost sounds like a bunch of marbles being tossed together. It just recently started happening or i might be going crazy because i didn't notice it before. It happens at idle, SOMETIMES. But it goes away the more i rev the engine. I'm not sure if i can't hear it because of my exhaust or if it actually goes away, but the sound DOSENT get louder the harder i drive it. In fact, the more gas i give it, it typically goes away but will occasionally come back. 

I did some research and i think it could be the lifters, i dont know too much about them besides that they help the valve open and close. Any remedy to this? And i'm i still safe to drive with it in the mean time? The weather is great now. 

 

If you're unaccustomed to engine internals and noises, you should cease driving it and seek a local mechanic. You only seem to be assuming it's lifters based on very little information. "Marbles" does not sound good. 

Alright so at the same time this tapping sound is happening, i'm also chasing a misfire from those red coil packs. On my way home from the store just now, it started misfiring really bad. I drove straight home immediately. The car was shaking at the stop light but it eventually went away when i started driving it. 

Could the tapping/knocking and the misfire be linked? 

When i say misfire, it acts like it dosent want to go past 4000k RPM for a few seconds and it eventually breaks past it and will drive normally. This happens very sporadically but on 50% of my drives. Spark plugs are already changed. 

1 hour ago, kevboost7 said:

Alright forum gods, i need your help again. RB26 just recently started making this very light tapping/knocking noise in the engine. It almost sounds like a bunch of marbles being tossed together. It just recently started happening or i might be going crazy because i didn't notice it before. It happens at idle, SOMETIMES. But it goes away the more i rev the engine. I'm not sure if i can't hear it because of my exhaust or if it actually goes away, but the sound DOSENT get louder the harder i drive it. In fact, the more gas i give it, it typically goes away but will occasionally come back. 

I did some research and i think it could be the lifters, i dont know too much about them besides that they help the valve open and close. Any remedy to this? And i'm i still safe to drive with it in the mean time? The weather is great now. 

 

I would start by making sure that it isn't rod knock or low oil pressure. Until you diagnose where the noise is coming from you aren't going to figure this out.

1 hour ago, r32-25t said:

Why are you still driving with those coil when you know they are faulty?

I felt bad just going maybe 50 yards with my cylinder 1 coilpack melting down, I have no idea how people are ok with doing this for miles and miles. The stock ECU is so basic it has no idea that something is wrong and to shut down fuel injection.

50 minutes ago, kevboost7 said:

I dont know, im just ignorant. im not driving it anymore till i figure it out. 

Well, at least there's some hope that the engine can still be salvaged if you didn't just drive on it until you windowed the block.

45 minutes ago, kevboost7 said:

I'm not taking it to the mechanic. 

That's where I'm at these days. Far too many cases where "good mechanics" have done something to my R33 so I no longer trust most people to work on it. As mentioned before none of us really know if your issue is rod knock or not. I just mention it because you want to eliminate the worst case possibilities first before spending time/effort/money/heartache on what I can only describe as copium/hopium fixes. 

description doesn't sound like classic rod knock, that tends to get worse from idle to 2000.

does it only happen when you are driving/full throttle/medium revs and sound like rocks rattling in a tin? that would be pinging.

Maybe take a recording of the noise to give us a chance

On 5/6/2023 at 2:38 PM, Duncan said:

description doesn't sound like classic rod knock, that tends to get worse from idle to 2000.

does it only happen when you are driving/full throttle/medium revs and sound like rocks rattling in a tin? that would be pinging.

Maybe take a recording of the noise to give us a chance

I agree but someone local to me had rocks rattling in a tin as the symptoms and it went away with load/revs. Turns out he was wrong to ignore it and it wasn't just a bad input shaft bearing or something like that. It's surprising how idiosyncratic failures can be.

  • Like 1
On 5/7/2023 at 1:28 AM, kevboost7 said:

I'm not taking it to the mechanic. 

You've got little mechanical knowledge, but an issue that could potentially cost you an engine you won't seek out a professionals help to at least start to diagnose?

 

Rattles like described can be a lot of things.

It could be lifters, it could be oil pressure issues, it could be a bearing noise, it could be a baffle in your exhaust.

 

Since you've also got issues on the coil packs, you may have other fatal issues that have now cropped up.

With the coil packs failing, did you ever have anyone or yourself adjust the position of the Cam Angle Sensor?

The car might be pinging off it's head down near idle (which could destroy your engine very quickly).

  • Like 2
2 hours ago, Dose Pipe Sutututu said:

*looks into crystal ball* 

kevboost7: I'm wondering how much a basic rebuild will cost? Also should I replace those red coil packs at the same time?

*Shakes magic 8 ball*

"No, keep the red coil packs with the rebuilt motor..."

  • Haha 1
On 09/05/2023 at 3:51 PM, Dose Pipe Sutututu said:

*looks into crystal ball* 

kevboost7: I'm wondering how much a basic rebuild will cost? Also should I replace those red coil packs at the same time?

 

On 09/05/2023 at 6:52 PM, MBS206 said:

*Shakes magic 8 ball*

"No, keep the red coil packs with the rebuilt motor..."

I hear that those yellow ones are better 🤣🤣🤣

  • Haha 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Initially I thought having a pair of Recaro seats would be a big bonus, it turns out these do get a little uncomfortable on long journeys (my fault, not the seat). I had a look through the GSM Performance website at reclining seats and booked an appointment to visit their show room. I got the Recaro Sportster CS for the R34 from here, was very happy with the service received so of course a re-visit was in order. Unfortunately the two Corbeau seats I had chosen aren't on display but they had 4 other options available. Two seats dug into my back, one dug into my legs and the other was perfect. I also found out that Recaro seats use a larger bolt pattern so some adaption was required. Luckily GSM offer some universal adaptors that should solve this problem. I searched the interwebs for price comparisons and Corbeau themselves were the cheapest at £300 cheaper (for the pair). I asked GSM if they could price match, unfortunately they couldn't. I later received an email saying Corbeau would honour them the same discount, but the purchase was already made. I did however order the brackets from GSM, both arrived on the same day. I started with the passenger side seat, knowing this was going to be a little trial and error. There are 3 mounting holes at the front and 2 at the rear on these JURAN Racing seat rails.  With the adaptor brackets mounted, the allen cap bolts started to push into the seat, NOT GOOD!  The rear mounting holes lined up but there were issues at the front. The holes were 1/2 hole out, so the brackets got a tickle with the drill to modify the holes. The supplied bolts weren't going to be long enough and a spacer was needed to stop the adaptor bars from bending. A local fasteners company supplied be with some nylon spacers and longer bolts (M8x30, although these will be replaced with 35mm long shortly) A before and after I pre-drilled the front bracket before making a start on the driver's seat to save some time. And in no time at all that was in the car too. The all black seats have transformed the interior and these are MUCH more comfortable. The only downside with the new Corbeau seats is I sit a little higher, but I'll happily accept that over discomfort. The Youtube video can be found here: https://www.youtube.com/watch?v=wPyttKPktXA
    • All 3 I guess. The car came with the JASI Aero 4 door Type R Full Kit unpainted so this was one thing at the top of my list to complete then I noticed there were body panels parts for this kit so i picked them up along with some black mesh to fill in the front bumper and front side air vents. car is at a paint and body shop atm completing this work. Next I will be addressing the internal bells and whistles, great summer project I can do with the kids.  full interior removal - ,boys car sound deadening - pads and spray ,boys stereo, sound, lighting - Big 3, GTT or bigger alternator ,kids head lining - dye black add star lighting mod ,daughter. That's it for the next 5-6 months. I have some motor maintenance  work i have to plan out. oil filter relocation, gaskets, mounts. beyond that, mind is starting to turn over if i can use a DET intake plenum, block off turbo ports & pipe in a air intake.      
    • roller coaster of a ride. Alarm system was removed & main harness was repaired where possible. still no fix just random successful starts. moved on to the replacing the ignition switch and relay. well all this troubleshooting & repair has been going on, the car is at a paint and body shop being pushed around. Ive been going down there on odd days after work to get it sorted.     
    • 5th November if you want to come out for a spin wakfield
    • PROBLEM WAS BROKEN COOLANT SENSOR!!! Replaced with a new one and its running mint.
×
×
  • Create New...