Jump to content
SAU Community

Recommended Posts

Mine has it and a mates has it here as well....

Behind the front wheel on the underneath of the floor plan rust has set it fairly well under the grey paint/sealant stuff they use from the factory. Mine had two bits about the size of a 50 cent piece on both sides in the same place....

I've hammered and sanded it back and sealed and bogged it. Mates was far worse with about 6 inches of rust on each side.

Its easy to miss cause you have to stick your head right under the car. If you've never looked get out there and look!

he he, cheers!

Link to comment
https://www.sau.com.au/forums/topic/79845-r32-rust-warning-problem-area/
Share on other sites

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

I can't get under it to get pics but if you look at the car side on. Where the side skirt is at the front look underneath there and you'll see it. It will be about 5 inches in. If its not there you're lucky.

Seems all the road muck and salt hits here first, hence the rust...

I've got rust at those spots too. also another place that is quite common is the rear quarter panel just behind the rear wheel. sometime the boot seals let water in there and rust starts from the inside out. mine is getting rust of the quarter panel taken off right now and i forgot to tell him about the other spot :) mite have to ring him. btw getting rust taken off is not cheap.

nOOSE

sorry to hear dude, mine is free from rust everywhere but in these spots....

I don't think it will get much worse with our usually dry climate. If I see it spreading however I will get it looked at. :)

Wonder how much it would cost to get rust out the floorpan, a left leg I think.....

  • 3 weeks later...
  • 2 weeks later...

omg rust on 32's is crazy. ive got a GTR and thank god im doin a full ground-up rebuild. i found two rust holes on each side on the floor where u guys were talking about. I also hav rust under the rear wheel arches in the bottom corners on both sides. ive got some pics from the inside, hopefully yours isnt this bad, but might be whats under your carpet.

Its really hard to find, i wouldnt have found it if i didn grind away all of the floor sealant, so u guys should do that as well. As for the wheel arches there was just a big hole that was easier to see. See the pic of where i had to fill it with seam sealer.

post-17897-1123411516.jpg

post-17897-1123412209.jpg

post-17897-1123412920.jpg

post-17897-1123413542.jpg

The whole car is currently being painted.

Rust found on drivers side, on the inside of the door frame, just under the latch.

Rust found around the rear windscreen seal. Pretty bad too - in between surface rust and body rust.

Rust found on the outer sills, but having some knob forklift your car and then park it on a wharf will do that every time :)

Also may have some being the LH headlight. Well it looks like there may be some back there. THe spot I mean would is being the fender.

Pics in my gallery *sigh* used to have easy links.

  • 9 months later...

Here is a few photo's from a horror story imported 1990 R32 GT-R to give you an idea of how bad some of the rust can really get!

Do not buy cars from the North of Japan, Do not buy R32's resprayed in white!

Drivers side surprise under the rear quarter skirt/pod

righthandsiderearquarterpanel0.jpg

Inside the drivers side rear quarter panel

interiorrighthandsiderearquart.jpg

The drivers side footwell

driverssidepassengerfootwell1o.jpg

The drivers side front wheel arch and chassis floor

righthandsidechassis6pc.jpg

Strut tower

enginebay25qc.jpg

The boot

righthandsideboot9rc.jpg

More surprises! Passenger side rear quarter under the pod/skirt

lefthandsiderearquarter5bj.jpg

Passenger side front chassis

lefthandfrontsidechassis7vl.jpg

Passenger side near rear bumper/rear quarter

righthandsiderearquarter44hh.jpg

Edited by Remix-

well thankfully i just completely pulled one of my 32s apart and there was no rust. acutally there was a tiny little piece of surface corrosion on the part of the rear quarter where the bumper usually covers. other than that it was fine. I did do one trick though which was remove the rubber bungs under the boot arear/rear quarter so that water (if it can get in) can get out.

I would not be surprised if Remix's R32 had been submerged in some natural flood disaster situation like they have at times in Japan.

What better way to dump a car after drying it out than at the auctions where all our cars virtually come from.

Otherwise maybe it came from prefectures where they put salt on the roads in the winters?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I'm selling my personal race car. 1992 BNR32 Skyline GT-R About eight years ago the engine developed the dreaded low oil pressure problem. I removed it and found the issue. However shortly after I moved half way across the country, moved my work shop, bought a house, got married, then moved my shop again to it's permanent location for the time being. in turn I do not have the time to race this car as it should be. In turn the engine I built for this car will end up in my street car and this car I hope finds a home with someone who can use it to it's full potential. The roll bar was built by Jason Noren Fabricaiton in Pomona California to SCCA and NASA Specs. The car used to compete in redline time attack and global time attack enthusiast class. It also has a fire suppression system.  The car is with me at my workshop in Kyle Texas, USA. Shipping it is no problem, I can personally deliver the car to the port of either Houston or Los Angeles. Any other port depending on where it is may require transport but we can always work that out.   The chassis itself is rust free, rear quarters and under fenders are free of any rust so it's a very solid foundation for anyone who wishes to move forward with it. As posted and at the asking price of $20,000 USD the car includes all of the following;   All OEM Body panels, front fenders, rear bumpers etc.  OEM Nissan Projector headlamps (Pictured N1 lamps were removed) OEM Nismo Side Skirts / Extensions OEM Rear Spats  Front & Rear Subframes are installed car is full roller Rear Subframe has Cusco Camber Arms, Whiteline HICAS Elimination Front Subframe has Whiteline tension rods and whiteline Sway bars w/ endlinks.  Buddy Club N1 Coilovers All chassis wiring and engine wiring is in tact. Attessa System is fully in tact and was functional before engine removal.  BCNR33 GT-R Brembo Brakes F+R with Endless MX72 Plus Pads, DBA Rotors & Stainless Steel Brake lines Billion Racing Radiator Billion Radiator Hoses Fluidyne Engine Oil Cooler Accusump System (trunk Mounted) 5 Speed Transmission w/ Transfer Case F+R Prop-shafts Rear Differential With rear Axles.  Nismo Gauge Cluster Nismo Clutch + Flywheel   Essentially what is needed to make this car running and driving again is as follows: A working Engine, an ECU, and time to put it together. The price posted is or best offer as I am willing to remove some components to accommodate price to a certain extent. If any serious buyer wants full detailed pictures, videos, or any questions I'll be happy to answer them. I believe this car is priced to move quickly considering it's a rust free and very straight chassis but always open to fair negotiation.  I can be contacted via phone or email. (+19517081648) email is [email protected]   
    • So...to my (and my mechanics doing the swap) surprise...the oil pan from NEO engine does not fit 100% and needs to by modified like this: It is not a huge problem but in the future i want a "proper" oil pan. So question is...what different oil pan can i get to fit without any problems and modification? Thanks! 
    • Some more info I found.  These are the last entries Yoshikiyo Fujii made on his blog before he passed away in 2009: http://blog.livedoor.jp/fujii_dynamics/ And finally this is where the workshop was situated:  https://maps.app.goo.gl/HhTPtHzt3WVcBTiEA  
    • shit boxes, kids, and daily drivers are all welcome
    • Cam seals go hard. It's a very old car.
×
×
  • Create New...