Jump to content
SAU Community

Recommended Posts

I doubt you will see 200 without bumping the boost up which will blow the turbo, and you will be limited to 200 anyway by the intake. Still it feels good at that level.

Are you getting injectors?

You will need a valve body upgrade for the auto before the tune.

i can help with that :thumbsup:

I doubt you will see 200 without bumping the boost up which will blow the turbo, and you will be limited to 200 anyway by the intake. Still it feels good at that level.

Are you getting injectors?

You will need a valve body upgrade for the auto before the tune.

Would upping it to 14/15 kill the turbo? I'm not terribly worried if it dies within a year...more worried about it dying in a week! Kyle's running his ARX at 15 atm...and if the stock boost on the ARX is 14 I don't see why an RS/RX can't handle 14?

Do I need injectors at this stage? Dont have an informeter so not sure what the injector's running at...I'm not 100% sure on injectors at the moment since I will most likely go down the LPG route depending on Sage222's results pending later this week. If this liquid injection stuff is as good as its marketed then I'll go down that road, hence a waste of $$ installing new injectors (which means a new fuel pump) now...

How much power can the stock fuel system take before carking it?

Valve body upgrade? Is that the $500 upgrade Aaron mentioned earlier? If not, how much, where, etc...

Edited by ironpaw

Would upping it to 14/15 kill the turbo? I'm not terribly worried if it dies within a year...more worried about it dying in a week! Kyle's running his ARX at 15 atm...and if the stock boost on the ARX is 14 I don't see why an RS/RX can't handle 14?

Do I need injectors at this stage? Dont have an informeter so not sure what the injector's running at...I'm not 100% sure on injectors at the moment since I will most likely go down the LPG route depending on Sage222's results pending later this week. If this liquid injection stuff is as good as its marketed then I'll go down that road, hence a waste of $$ installing new injectors (which means a new fuel pump) now...

How much power can the stock fuel system take before carking it?

Valve body upgrade? Is that the $500 upgrade Aaron mentioned earlier? If not, how much, where, etc...

RVO in dandenong for about $550 installed. I should be taking my POS there in the next week or two to get done. i'll let you know the worthiness

RVO in dandenong for about $550 installed. I should be taking my POS there in the next week or two to get done. i'll let you know the worthiness

Hmmm.... I have heard another M35 owner speak of his car in similar terms... must be a black ARX thing :P

Hmmm.... I have heard another M35 owner speak of his car in similar terms... must be a black ARX thing :P

its very un stagea like of me, but im seriously getting sick of the thing.

Would upping it to 14/15 kill the turbo? I'm not terribly worried if it dies within a year...more worried about it dying in a week! Kyle's running his ARX at 15 atm...and if the stock boost on the ARX is 14 I don't see why an RS/RX can't handle 14?

Do I need injectors at this stage? Dont have an informeter so not sure what the injector's running at...I'm not 100% sure on injectors at the moment since I will most likely go down the LPG route depending on Sage222's results pending later this week. If this liquid injection stuff is as good as its marketed then I'll go down that road, hence a waste of $$ installing new injectors (which means a new fuel pump) now...

How much power can the stock fuel system take before carking it?

Valve body upgrade? Is that the $500 upgrade Aaron mentioned earlier? If not, how much, where, etc...

200 is about the limit of everything, but you probably wont get there on the stock turbo anyway, I didnt even crack 180.

^ those wheels look awsome. now put em on the car lol

I got my map/boost sensor in for the emanage today.. now im ready for a tune..

...oh wait i still need a turbo :(

Mind if I ask where you picked up the sensors? :)

+1, spotted the adaptor, for $150 delivered, but still need sensors.pinch.gif

Resealed a couple of leaking trans cooler fittings, goo didn't like ATF :spank: so now I'm using proper hydraulic sealant like I should have...

Removed damaged D bush from front sway bar and refitted factory bits, much better. A little disappointed TBH. Going to look for urethane bushes to suit factory D mounts, front & rear.

Also just bought one of these;

http://cgi.ebay.com/...MEWAX%3AIT#shId

Edited by Daleo

Mind if I ask where you picked up the sensors? :)

+1, spotted the adaptor, for $150 delivered, but still need sensors.pinch.gif

Resealed a couple of leaking trans cooler fittings, goo didn't like ATF :spank: so now I'm using proper hydraulic sealant like I should have...

Removed damaged D bush from front sway bar and refitted factory bits, much better. A little disappointed TBH. Going to look for urethane bushes to suit factory D mounts, front & rear.

Also just bought one of these;

http://cgi.ebay.com/...MEWAX%3AIT#shId

Its an original Greddy Boost/pressure/map sensor.

http://cgi.ebay.com....e=STRK:MEWAX:IT

$145.00 all up free P&H.. I dont know where your looking lol

I found the adaptors for $20.00

Edited by AaronNM35

Its an original Greddy Boost/pressure/map sensor.

http://cgi.ebay.com....e=STRK:MEWAX:IT

$145.00 all up free P&H.. I dont know where your looking lol

I found the adaptors for $20.00

Ok, I was looking at this; http://cgi.ebay.com/...e=STRK:MEWAX:IT mainly because I want to run an oil temp sender as well.

Ok, I was looking at this; http://cgi.ebay.com/...e=STRK:MEWAX:IT mainly because I want to run an oil temp sender as well.

yep so you can use, i think, four sensors.

I was looking to buy it for oil temp/pressure, and if I can exhaust temp or AFR.. but not sure if i can.. havent come accross a sensor that fits(and is accurate)

Edited by AaronNM35

What size? Do tell!!!

lol.....was just mucking around....there are 18" x 10" single bolt from the race car!

mind you that profile does fit the guards pretty well!

lol.....was just mucking around....there are 18" x 10" single bolt from the race car!

mind you that profile does fit the guards pretty well!

I did notice there was no stud pattern, I thought maybe it was some bizarre generic 'test fit' rim rofl.gif

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
×
×
  • Create New...