Jump to content
SAU Community

Recommended Posts

Just north of Newcastle past Raymond Terrace, Buckets Way through Gloucester, Walcha/Uralla. Then you're close enough to Armidale or Tamworth. Long drive. No traffic. Bendy bits and open bits http://www.skylinesaustralia.com/forums/public/style_emoticons/#EMO_DIR#/smile.gif

I don't like Old Pac. Too busy and not enough visibility.

Did this again recently, awesome drive, had it mostly to myself, lots of fun. Road is in a terrible state, best avoided if you have rock hard setup. Debating if I will go this way home.

  • 1 year later...
  • 6 months later...

Macquarie pass up to the pie shop, down through jamberoo mountain road, down to Kiama and then along to Berry. From Berry through Kangaroo Valley Road and up Moss Vale Road into Bowral.

Only got through the first two sections and then mates car broke down, but was very good road. Need to go early to avoid traffic.

Mount Keira Rd is also very good.

  • Like 2

Awesome thread, I absolutely believe that motor vehicles encapsulate all that is brilliant about the human spirit - the engineering, the style, the passion.

However, it's depressing to see the older posts talking about open roads in good condition and with little traffic and hassle from the police, when these days speed limits have been dropped to artificially low levels and police and cameras have a stronger presence than ever. It's only going to get worse, unfortunately.

My 2 cents to add about the roads - Putty Road is great if you like open road and cruising - frankly i got bored and found it a waste of fuel (except for one tiny section with the bends).

Used to live right on Bells Line of Road, the Bellbird Hill section is GREAT but really short, and there is traffic nearly around the clock, especially weekends.

Old Pac between Hornsby up to Central Coast was the best fun I've had on the road, ever. I was flooring it, but i wasn't going hard in corners and kept it will within my limits.

I want to try Royal Nasho, but there has been a heavy police presence as I understand recently. Few absolute n00bs have been driving beyond their limits and crashing too (mostly s-chassis it seems! lol)

Would love to hear anyone else chime in with recent road reports

The problem with Old Pac and Nasho, is that they are mostly 60km/h in the fun bits, so "spirited driving" and police presence will almost certainly result in a significant fine. That and the ubiquitous steady stream of near stationary Camry's "sightseeing"...

I'm over driving on those roads in search of fun. There are plenty of awesome roads on the other side of the dividing range, or down south is where I choose to ride and drive.

Not as many coffee shops, and you can't be precious about stone chips and low lips; but a solid pub meal and a cold beer in front of a roaring fire will be your reward.

  • Like 1

Macquarie Pass seemed to have got more and more popular with NSW sightseers, causing a lot more police presence.

Yes, the ones where they drive around in first until the overtaking lanes, where they gun it.

Don't know any other good roads. Haven't done National Park in years, but the surface was typical Sydney shit so avoid it. Mac pass is smooth, excellent driving road.

Macquarie pass up to the pie shop, down through jamberoo mountain road, down to Kiama and then along to Berry. From Berry through Kangaroo Valley Road and up Moss Vale Road into Bowral.

Only got through the first two sections and then mates car broke down, but was very good road. Need to go early to avoid traffic.

Mount Keira Rd is also very good.

This is a full day of driving and well worth it (from Sydney).

Just to recap...

* Up Macquarie Pass (from Albion Park) to the pie shop

* Down Jamberoo Mtn Road (from the pie shop) to Kiama and then proceed south

* Up Kangaroo Valley Road (from Berry) to Kangaroo Valley

* Down Cambewarra Mountain along Nowra Rd to Bomaderry and turn left to Sydney (keeping watch for several fixed speed cameras)

OR turn right through Kangaroo Valley township towards Bowral

  • Like 3

My favorite routes

Nasho through Heathcoat road but get on at Waterfall (not full run) as I'm sure thousands have said though there is plenty of cops and plenty of animals.

Recently discovered old pac which is a great run

My all time favorite run will forever

Bells line of road, across Darling Causeway and back down to the M4 or in reverse starting at the M4 and going up then across and back down

There is a great place on the way up Bells line called apple bar which is a great place to stop in.

  • Like 3
  • 4 months later...
  • 1 month later...
  • 1 year later...
On 31/10/2014 at 0:59 PM, GTR-N1 said:

Mitchells Pass Rd Blaxland to Emu Heights, now has armco nearly all the way down.

Still no speed sign on the eastern side of Lennox Bridge.

The 6 existing speed humps before the bridge are now taller/lumpier.

 

  • 4 months later...
  • 4 years later...

Did a run with a group of car enthusiasts from FB, Sydney to Mt Panorama, via Oberon, was the best day of GTR ownership, tops anything else I’ve done with the car, left home at 5am, didn’t get back home till 5pm. Amazing run with a fantastic group of people and the GTR was flawless. Was such a rewarding drive, car did everything I asked of it, with ease.
Did almost 500km of driving that day, car was E85 only, used 1 x tank and 30 litres from Jerry cans. 
 

A52C8BD8-D8B6-4CFA-BEE3-45A6F6092E55.jpeg

BEC6F8AA-EF30-4A68-B7B2-B16DF47CB91F.jpeg

1FA2D25D-C1A1-4019-AD4B-3B04ED95F7A8.jpeg

23124E43-6D9B-4A6D-BD87-92EAE795D584.jpeg

6CECFD25-D9FF-4510-A29F-29F6B1E9483D.jpeg

0FBFC97B-32FE-4DD9-AB3D-85E64CC6BC61.jpeg

B954FAA4-4417-4C60-BCF4-47E68B479394.jpeg

  • Like 4
  • 6 months later...

 Bells line is usually my go to for a blast and unwind, but watch out for the native fauna - I had an issue last weekend when I tried to install a non-genuine Mitsubishi wombat into my Legnum VR-4. If you've ever wanted to know the fastest way to jack up a vehicle - hitting a wombat at 80kph is probably it.

 Split the front bar & felt it batter the floor-pan & undercarriage. Thought it was a boulder or log at first - doubled back to find out and was astounded to see it was actually a marsupial. Happened in east Bilpin - about 40k west I encountered another one but someone else had nailed him. He was still twitching so I went back to the car for my baton and finished the job.

Just a reminder that speed doesn't only kill those of us driving - but sometimes also the creatures that co-exist among us.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi, SteveL Thank you very much for your reply, you seem to be the only person on the net who has come up with a definitive answer for which I am grateful. The "Leak" was more by way of wet bubbles when the pedal was depressed hard by a buddy while trying to gey a decent pedal when bleeding the system having fitted the rebuilt BM50 back in the car, which now makes perfect sense. A bit of a shame having just rebuilt my BM50, I did not touch the proportioning valve side of things, the BM50 was leaking from the primary piston seal and fluid was running down the the Brake booster hence the need to rebuild, I had never noticed any fluid leaking from that hole previously it only started when I refitted it to the car. The brake lines in the photo are "Kunifer" which is a Copper/Nickel alloy brake pipe, but are only the ones I use to bench bleed Master cylinders, they are perfectly legal to use on vehicles here in the UK, however the lines on the car are PVF coated steel. Thanks again for clearing this up for me, a purchase of a new BMC appears to be on the cards, I have been looking at various options in case my BM50 was not repairable and have looked at the HFM BM57 which I understand is manufactured in Australia.  
    • Well the install is officially done. Filled with fluid and bled it today, but didn't get a chance to take it on a test drive. I'll throw some final pics of the lines and whatnot but you can definitely install a DMAX rack in an R33 with pretty minor mods. I think the only other thing I had to do that isn't documented here is grind a bit of the larger banjo fitting to get it to clear since the banjos are grouped much tighter on the DMAX rack. Also the dust boots from a R33 do not fit either fyi, so if you end up doing this install for whatever reason you'll need to grab those too. One caveat with buying the S15 dust boots however is that the clamps are too small to fit on the R33 inner tie rod since they're much thicker so keep the old clamps around. The boots also twist a bit when adjusting toe but it's not a big deal. No issues or leaks so far, steering feels good and it looks like there's a bit more lock now than I had before. Getting an alignment on Saturday so I'll see how it feels then but seems like it'll be good to go       
    • I don't get in here much anymore but I can help you with this.   The hole is a vent (air relief) for the brake proportioning valve, which is built into the master cylinder.    The bad news is that if brake fluid is leaking from that hole then it's getting past the proportioning valve seals.   The really bad news is that no spare parts are available for the proportioning valve either from Nissan or after market.     It's a bit of a PITA getting the proportioning valve out of the master cylinder body anyway but, fortunately, leaks from that area are rare in my experience. BTW, if those are copper (as such) brake lines you should get rid of them.    Bundy (steel) tube is a far better choice (and legal  in Australia - if that's where you are).
×
×
  • Create New...