Jump to content
SAU Community

Recommended Posts

Question:

Bike I'm looking at buying has finance on it after doing PPSR check, what steps do I need to take if I want to buy it or just steer clear completely??

Nah, you're sweet bro.

Steer clear the finance company will not tell you the payout figure and you run a risk of the seller not paying the finance.. by law the bike can be repossessed without any question

When I bought my 1st gtr, I contacted finance company requesting a figure saying I have seller's permission to ask, and they gave me a figure and I made a bank cheque payable to the finance company, seller ended up gave me loose change cos it was like $11 or something more than asking price.

T'was kinda strange experience of receiving loose change and keys at the end of transaction.

Kids on the way mate?

lol nah the audi turned to a heap of shit so got this ill get it stickered up with work branding for couple of years then give it to the wife it's a bit of a stop gap cos I want the Lexus rc but isn't out and couldn't wait. Tell ya what though it's top of the range and you'd pay at least 40-50k more for a similar spec level in a German brand which seems a bit silly to me these days

cool thanks for the response.. I think it looks like he has it on his mortgage.. wonder if that'll make it even harder.

I sincerely doubt that.

If he has restructured his mortgage to include the bike, the bike will likely now be unencumbered.

There is not a lot (read 0) incentive for a banker to bother registering a charge to a measley $14k asset to secure a mortgage, let alone one that will depreciate rapidly. I wouldn't even be able to use one as security for a house if I wanted to bother due to depreciation vs loan term.

Not to mention, depreciating assets really cant be used as regulated home loan security anyway... as a business product it is technically possible, however highly stupid and extremely unlikely

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...