Jump to content
SAU Community

Recommended Posts

When I had huge new NT05s 2nd was half decent, once they got a bit worn a old skate sesh.

Now I'm rocking dunlop 245s pretty good, holds 1st and 2nd brah. such grip. wow.

Edited by UNR33L

Depends what tyres you have I reckon. My setup was only just holding second when the tyres were new...I'd like to be able to put foot flat to the floor and not have to pull back on boost cause of wheelspin. 300 on E85 would be semi slicks and still break it in 2nd I reckon.

you run KU31's don't you...

I had traction through with 320rwkw and NT05's

you run KU31's don't you...

I had traction through with 320rwkw and NT05's

On the front

Got R1R Proxes on the rear

Prolly not as good in the dry as NT05s but I bought them as a wet compromise cause NT05s are deadly in the wet lol

How big were your NT05s?

so much learning to modulate throttle needed.

do some track days and learn to drive it properly.

None of this street hero business.

speaking of business

Qantas Bushiness upgrade for tonights flight to Dubai..nice.

  • Like 1

Try the evo in the wet.

235 kinforests (im not even kidding) and you can launch it in the wet with traction through all gears lol

Granted is only 175kw atm but still it's spastic

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...