Jump to content
SAU Community

Recommended Posts

that supra has been doing the rounds for a while, bout time it proved its dyno queen abilities.

That RTR dyno has been known to pull lower numbers. the SAU dyno day with RTR had a 32R with -5's and 2x R35's at the top, none pushing more than 350kw

that supra has been doing the rounds for a while, bout time it proved its dyno queen abilities.

That RTR dyno has been known to pull lower numbers. the SAU dyno day with RTR had a 32R with -5's and 2x R35's at the top, none pushing more than 350kw

350kw isn't low numbers for any of those cars though.

When Mohsen's car wheelspins, they're not strapping the cars down correctly :P

Additionally... https://www.facebook.com/100millimetre/videos/680627765399956/

This should have be wheel spinning all over the place if the dyno couldn't handle 300rwkw petrol cars

So, went to start car today, fuel pump refuses to prime.

sigh

if it makes you feel any better greg, im still buying pieces for the pulsar to replace pieces i have bought less than 2 years ago.

latest item was a $350 odyssey battery that the car killed and i still havent figured out why.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...