Jump to content
SAU Community

Recommended Posts

2 hours ago, Dose Pipe Sutututu said:

You mean you run E85 full time.

PowerFC can't even cut power when you're above a particular load point, it can't even cut power when you've exceeded a particular engine water temperature.

I think you need to admit now that it is a pretty basic ECU.

Nistune can do full flex blending (PowerFC cannot), Nistune has basic engine protection (PowerFC will grenade your motor), Nistune you can vary your VCT (PowerFC you cannot), Nistune has launch control (PowerFC does not have), Nistune you can fully map the DC for the boost solenoid (PowerFC you cannot).

So tell why the PowerFC is better? Because of its useless hand controller?

Relax man.. was only a suggestion, it does sound good now from what you've said.. For a budget slapper with a $200 bottom end it works fine for me, obviously a haltech would be best..

I said i run flex as in eflex from united.

Did the nistune save your boat?

Edited by AngryRB
  • Haha 1
Link to comment
https://www.sau.com.au/forums/topic/474557-r34-nat/page/2/#findComment-7881724
Share on other sites

Don't be obtuse.  It's not the definition of "flex" when referring to what fuel a car can run on.  That is a fuel company somewhat deliberately confusing matters.  It's also a far smaller slice of the ethanol market than is represented by United, which conveniently calls the fuel by a name that represents what it actually is.

  • Like 2
Link to comment
https://www.sau.com.au/forums/topic/474557-r34-nat/page/2/#findComment-7881791
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...