Jump to content
SAU Community

Recommended Posts

out at morwell today and had no idea the smoke was so bad from the coal fire going on. you can see the ash in the air, it's building up on the cars. I don't know how the EPA deems it ok to be outside for extended periods.

epa dont know about it.

too busy sending out letters to car drivers.

  • Like 1

sorry to hear. didnt think JZ would be your thing

jay-z.jpg?w=680

Celsior or cressida with 1UZ is where its at for toyotas. JZ's too pricey.

you know big engine toyotas Alvin, what you think?

as mentioned, they're smooth and all, but they lack everything else, power, torque, and are put in cars too heavy for them.

needs turbro in the boot. coolant/radiator set up in the 1uz snorer is stupid, things are overly complicated.

just go 1J.

out at morwell today and had no idea the smoke was so bad from the coal fire going on. you can see the ash in the air, it's building up on the cars. I don't know how the EPA deems it ok to be outside for extended periods.

They issued advice to residents to consider evacuating today apparently due to the air quality (or lack thereof) as they can't guarantee how much longer it'll be like that.

sooo... 892kms on the hilux and it decides to run out of fuel.

stoopid gauge design... ill take a pic later. The needle and lines are misleading. its a terrible dash in general. instead of lines representing 60km/h, 80, 100 etc, it has a solid line all the way round then gaps missing on the 60, 80, 100 marks. actually makes it difficult to gauge if youre under or over speed limit. and of course their lever design reads 500kms in first half of tank and 400 on the second half. f**king toyotas.

sooo... 892kms on the hilux and it decides to run out of fuel.

stoopid gauge design... ill take a pic later. The needle and lines are misleading. its a terrible dash in general. instead of lines representing 60km/h, 80, 100 etc, it has a solid line all the way round then gaps missing on the 60, 80, 100 marks. actually makes it difficult to gauge if youre under or over speed limit. and of course their lever design reads 500kms in first half of tank and 400 on the second half. f**king toyotas.

Aw, poor you.

sooo... 892kms on the hilux and it decides to run out of fuel.

stoopid gauge design... ill take a pic later. The needle and lines are misleading. its a terrible dash in general. instead of lines representing 60km/h, 80, 100 etc, it has a solid line all the way round then gaps missing on the 60, 80, 100 marks. actually makes it difficult to gauge if youre under or over speed limit. and of course their lever design reads 500kms in first half of tank and 400 on the second half. f**king toyotas.

Get a pulsar

How many kw can a R33 GT-R fuel pump support in my gts-t? Ceebs going 040...

I've seen them pump out enough fuel to support 450rwkw in a GTR. I've also seen them run out of puff at 330rwkw. Luck of the draw really but will be more than you need.

I've seen them pump out enough fuel to support 450rwkw in a GTR. I've also seen them run out of puff at 330rwkw. Luck of the draw really but will be more than you need.

How much voltage they're receiving is a huge factor in the flow rate (and I'm sure km's also could be a factor)... Wire it up using a relay to get full voltage instead of 15yo thin wiring designed for a smaller pump and you'll be laughing.

  • Like 1

I spy a Simon

attachicon.gif20140226_182819.jpg

Oh hai... Was on my way to the SAUVIC AGM, which was only 10 minutes from here.... or 1 minute if I had turned left instead of right at this intersection.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...