Jump to content
SAU Community

Recommended Posts

also, bought car with cooked motor, you just did a mohsen.

seriously now.

do LS TT

no... buying a car with a blown motor would only be a mohsen if the motor blew on the drive home

Still deciding, it will really depend what comes up. If a built 26 pops up, I'll consider that for a cheap and risky way out. Otherwise, budget may allow for RacePace to rape my wallet.

Was making 340awkw with the HKS turbos before engine issues (it's actually still quite driveable and the engine idles smoothly besides the sound, so don't know how far gone it is), which sounds plenty for me in a street car. I'd like to put it on sugar cane for response, though.

On the cosmetic side of things

This was a very nice 33R at Sandown on the weekend

10917414_697478720373864_108591382654288

10917109_697478693707200_424280051460900

Thanks gents

It's gotta get to Melbourne first and that was an absolute nightmare organising transport on the day I was supposed to be flying back :O

Transporter knocked it back cause needed 15cm ground clearance so I had to remove the front lip and leave it in ACT...no biggie as it was damaged anyway. Took off the brake ducts too but they are with me.

Still deciding, it will really depend what comes up. If a built 26 pops up, I'll consider that for a cheap and risky way out. Otherwise, budget may allow for RacePace to rape my wallet.

Was making 340awkw with the HKS turbos before engine issues (it's actually still quite driveable and the engine idles smoothly besides the sound, so don't know how far gone it is), which sounds plenty for me in a street car. I'd like to put it on sugar cane for response, though.

Chuck a thicker oil and she'll be right moite.

I've done my share of interstate car towing...prolly would have if I still had access to a race car trailer and time wasn't an issue.

$400 depot to door from Canberra, pretty happy with that.

  • Like 1
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...