Jump to content
SAU Community

Recommended Posts

I've always said the counterpart, and that's that no matter how fat/unattractive/bitchy/redhaired a woman is, there is always an equally desperate dude out there who would bang her...or one with a fetish for that...

the point platts was trying to make is that its not the other way around (fat/unattractive/bitchy/redhaired a man is)

Suspension shop says rear upper control arms would make life a lot easier fitting the new wheels... found some in japan... $1200 before delivery. yeah nah.

apparently the S13 front LCA's dont fit... found some in japan... $1600 before delivery. somewhere someone is making some moolah off suspension bits. with so many cars in japan land running -60 offset and -4mm ground clearance and -12 degrees camber.

This conversation actually happened just now

Birds: (singing) I got hoes, I got hoeeees

Leesh: (pissed off) heyyy!

Birds: What, I do have hoes

Leesh: Where?

Birds: ...........IN DIFFERENT AREA, AREA, AREA CODES

  • Like 6

This conversation actually happened just now

Birds: (singing) I got hoes, I got hoeeees

Leesh: (pissed off) heyyy!

Birds: What, I do have hoes

Leesh: Where?

Birds: ...........IN DIFFERENT AREA, AREA, AREA CODES

well there goes your massage tonight

the point platts was trying to make is that its not the other way around (fat/unattractive/bitchy/redhaired a man is)

Suspension shop says rear upper control arms would make life a lot easier fitting the new wheels... found some in japan... $1200 before delivery. yeah nah.

apparently the S13 front LCA's dont fit... found some in japan... $1600 before delivery. somewhere someone is making some moolah off suspension bits. with so many cars in japan land running -60 offset and -4mm ground clearance and -12 degrees camber.

Are you still fucking around trying to fit #vip #stance #flush #camber #fitment #stanceworks #hashtag #iscrape #jdmtyte # genuine #notfake #realjdm #6pce #wheelporn #hellastance rims with non-stretched tyres because you "don't do stance?"

im just trying to make work with what i have.

if i was to do it again i would get a smaller offset. but hindsight and trial and error is a wonderful thing.

Just get smaller tyres.

You are trying to put a square peg in a round hole.

  • Like 1
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The issue now is the 'fuel cut' while driving, and when it happend, it does not stall. This, I did not test the fuel pressure while driving as I cannot with a fuel pressure gauge. I do have Nistune logs, yes. I have also replaced the MAF Sensor.   Also related to the FPG Fuel Hanger – I just realized that I need a Deutsch Crimp Tool to crimp some cables for the FPG Fuel Hanger. Need to purchase additional cables as the kit only included 2, which are for the float. FPG has not responded to my emails so far since purchasing. I thought about taking it to someone and having it done professionally, but I am reluctant since everyone I took it to messed up in some way.  
    • There's a good German place in Brisbane if youre up for the drive 😛
    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
    • I would say no, why, because my daughter, who also lives in Goulburn, hasn't recommended us going there Pity, as we miss all the German joints around in Sydney, actually, the restaurants are the only thing I really miss about Sydney, and a special mention to Ishibanboshi at Bondi Junction, their Kara-age Don is heart cloggingly deliciousness (always added a special boiled egg...or 2) 😋 
×
×
  • Create New...