Jump to content
SAU Community

Recommended Posts

On 08/11/2021 at 10:01 AM, r32-25t said:

 It German beer is much better then Korean beer 

This I have to agree too, also their sausages are better.

Went to their beer festival a few years ago in Berlin, that was great fun! RSA? yeah nah, here's a pint and a landyard so you don't drop your beer.

 

Fab Brief: must use existing hole, don't want a new hole through the washer bottle like all the other R33 GTS-ts out there. Also minimum pie cuts where possible (I reckon they're ugly).

Result: Pretty damn happy with this 😁

IMG_20211109_123121_967.thumb.jpg.d274f790d1405b213471b9babddf9cdb.jpg

IMG_20211109_123111_542.thumb.jpg.0617144201d6200163d0df9a039a356f.jpg

 

  • Like 4

New hot pipe too, because why not. Also the existing one didn't fit too well as it was made to suit a HDi intercooler which sat a bit more forward when compared to the Plazmaman Pro core.

We haven't discussed cost yet 😅

 

IMG_20211111_161900_859.jpg

IMG_20211111_161910_746.jpg

IMG_20211111_161848_942.jpg

  • Like 3
On 12/11/2021 at 3:35 AM, Piggaz said:

No clamps behind the front bar?

As in the Plazma clamps? Nah normal silicone joiners and hose clamps are fine for me. Only going to run about 2 to 2.2bar of boost.

The TB, had no choice because of the DBW adaptor.

On 11/13/2021 at 4:37 PM, Dose Pipe Sutututu said:

Just confirms how mentally retarded I am throwing more money at it 😐

I think this applies to all of us here 

timmy burch repeating GIF by South Park

  • Like 1
  • Haha 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Keeping in mind that for most people this is a week to month long job!
    • Its also worth mentioning that 30 years after it left the factory and god knows how many missed oil changes since, there is every possibility that one or more lifters are ticking because they are sticky/gummed up. To resolve that you need to pull the cams then pull each lifter, disassemble, clean, reassemble, soak in oil and re-install, and they should come up good as new.
    • What air filter are you running? Is it a panel filter in the stock air box, or a pod filter? Is the air filter the type that is oiled?   If you unplug the IACV, what rpm does the engine idle at?
    • Reading through the engine service manual their advice is do a cylinder balance test. Unplug one injector at a time and see if the idle drops a consistent RPM. You can also do this using a Consult cable which is easier. They also call for unplugging the power transistor, then with the engine off and the fuel rail unhooked from the manifold verifying that you have good fuel flow (even injection, no dripping/leaks, etc) when you twist the CAS by hand. Also verify the spark by pulling the spark plugs and allowing the plugs to ground and turning the CAS by hand. I would also start doing the sensor checks and idle valve checks in service manual. Make sure the MAF tests reasonably, the intake air regulator is sane, etc. You may have to get new spark plugs.
    • This sounds very old of me, however since buying the Tiguan shit box, my view on shit boxes have changed.
×
×
  • Create New...