Jump to content
SAU Community

How much are you paying for CTP Greenslip


Recommended Posts

21 hours ago, deongster said:

i need a CTP for the Jazz - its freaking $890 NRMA now... THAT IS MAD!!!!

Screen Shot 2016-10-14 at 9.58.38 AM.png

Whoooooh!

I paid $361 for my Tiida for 12 months with QBE and $387 for the R34GTR on the 26/4/16

It must have something to do with a persons age,  where they live and or their driving record I guess when they give you a quote ??????????????????

That is ridiculous!  My 32 GTR was $890 with NRMA.  25yo clean driving record



Looks like $890 is the number now. Bloody expensive. I have to get for the Pathfinder and GTR in May next year. I fear it.
20 minutes ago, deongster said:

 

 


Looks like $890 is the number now. Bloody expensive. I have to get for the Pathfinder and GTR in May next year. I fear it.

time to 'move' to the central coast. $280 cheaper there :(

Well Terry, quotes are above $800 these days, so I'd say so.
I still don't see the reason for the massive increase in the past 5 years. More dodgy claims? Yes, but why almost double it?
Just an unregulated cash grab, and us suckers stuck in Sydney have no choice but to pay it (apart from not having an address to register to outside of Sydney).

Hell even the NSW Government hopped on the bandwagon and doubled the "motor vehicle tax".

7 hours ago, Terry_GT-R34 said:

So is it correct (or incorrect), that CTP Insurance is cheaper outside of the Sydney Metropolitan Area?

Terry, you only have to look at we pay outside of Sydney to answer your question.

Same company , same type car and half the price.

There are pockets of people in Sydney (and other areas) that make big money by manufacturing claims, you can win a camel saddle if you can guess where ?

I always knew that was the case quite a few years ago. My Q I  should have clarified, pertains to recency. 

Ok, so nothing has changed from when I knew that CTP premiums were always more expensive in Penrith compared to Emu Plains.

9 hours ago, Terry_GT-R34 said:

I always knew that was the case quite a few years ago. My Q I  should have clarified, pertains to recency. 

Ok, so nothing has changed from when I knew that CTP premiums were always more expensive in Penrith compared to Emu Plains.

Until these threads on CTP started I did not know there was any difference in costs depending where you lived etc, I thought it was a flat rate across the board and as usual the good pay for the bad :/ 

  • Like 2

in other news

http://www.insurancebusinessonline.com.au/au/news/breaking-news/ctp-changes-could-see-drivers-require-income-protections-insurance-225196.aspx

 

really not sure how NSW is so shit at CTP. QLD has a different system and seems to work well and is affordable. Why cannot there be a nation-wide system?

  • Like 2
2 hours ago, evil_weevil said:

in other news

http://www.insurancebusinessonline.com.au/au/news/breaking-news/ctp-changes-could-see-drivers-require-income-protections-insurance-225196.aspx

 

really not sure how NSW is so shit at CTP. QLD has a different system and seems to work well and is affordable. Why cannot there be a nation-wide system?

Going through rego in QLD atm I can vouch for this :D $380 state wide for Class 1 (i.e. Car and stationwagon) interestingly... $75 for ' vintage, veteran, historic or street rod motor vehicles'

  • Like 1

Just did a simple quote for my GTR - due next year May

$612 per annum - WTF such big difference...

$894 for the Honda Jazz 1.3 - has 3rd party Fire & Theft - saw no point paying so much for Comprehensive for a $3000 car... why such VAST difference... do not get it...

SAU > General Automotive > Savings on CTP in NSW Whilst With NRMA VVC...

My story this morning of how I saved $280 by going to a NRMA Branch and asking for an adjustment, rather than pay online or by phone

 

 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Power is fed to the ECU when the ignition switch is switched to IGN, at terminal 58. That same wire also connects to the ECCS relay to provide both the coil power and the contact side. When the ECU sees power at 58 it switches 16 to earth, which pulls the ECCS relay on, which feeds main power into the ECU and also to a bunch of other things. None of this is directly involved in the fuel pump - it just has to happen first. The ECU will pull terminal 18 to earth when it wants the fuel pump to run. This allows the fuel pump relay to pull in, which switches power on into the rest of the fuel pump control equipment. The fuel pump control regulator is controlled from terminal 104 on the ECU and is switched high or low depending on whether the ECU thinks the pump needs to run high or low. (I don't know which way around that is, and it really doesn't matter right now). The fuel pump control reg is really just a resistor that controls how the power through the pump goes to earth. Either straight to earth, or via the resistor. This part doesn't matter much to us today. The power to the fuel pump relay comes from one of the switched wires from the IGN switch and fusebox that is not shown off to the left of this page. That power runs the fuel pump relay coil and a number of other engine peripherals. Those peripherals don't really matter. All that matters is that there should be power available at the relay when the key is in the right position. At least - I think it's switched. If it's not switched, then power will be there all the time. Either way, if you don't have power there when you need it (ie, key on) then it won't work. The input-output switching side of the relay gains its power from a line similar (but not the same as) the one that feeds the ECU. SO I presume that is switched. Again, if there is not power there when you need it, then you have to look upstream. And... the upshot of all that? There is no "ground" at the fuel pump relay. Where you say: and say that pin 1 Black/Pink is ground, that is not true. The ECU trigger is AF73, is black/pink, and is the "ground". When the ECU says it is. The Blue/White wire is the "constant" 12V to power the relay's coil. And when I say "constant", I mean it may well only be on when the key is on. As I said above. So, when the ECU says not to be running the pump (which is any time after about 3s of switching on, with no crank signal or engine speed yet), then you should see 12V at both 1 and 2. Because the 12V will be all the way up to the ECU terminal 18, waiting to be switched to ground. When the ECU switches the fuel pump on, then AF73 should go to ~0V, having been switched to ground and the voltage drop now occurring over the relay coil. 3 & 5 are easy. 5 is the other "constant" 12V, that may or may not be constant but will very much want to be there when the key is on. Same as above. 3 goes to the pump. There should never be 12V visible at 3 unless the relay is pulled in. As to where the immobiliser might have been spliced into all this.... It will either have to be on wire AF70 or AF71, whichever is most accessible near the alarm. Given that all those wires run from the engine bay fusebox or the ECU, via the driver's area to the rear of the car, it could really be either. AF70 will be the same colour from the appropriate fuse all the way to the pump. If it has been cut and is dangling, you should be able to see that  in that area somewhere. Same with AF71.   You really should be able to force the pump to run. Just jump 12V onto AF72 and it should go. That will prove that the pump itself is willing to go along with you when you sort out the upstream. You really should be able to force the fuel pump relay on. Just short AF73 to earth when the key is on. If the pump runs, then the relay is fine, and all the power up to both inputs on the relay is fine. If it doesn't run (and given that you checked the relay itself actually works) then one or both of AF70 and AF71 are not bringing power to the game.
    • @PranK can you elaborate further on the Colorlock Dye? The website has a lot of options. I'm sure you've done all the research. I have old genuine leather seats that I have bought various refurbing creams and such, but never a dye. Any info on how long it lasts? Does it wash out? Is it a hassle? What product do I actually need? Am I just buying this kit and following the steps the page advises or something else? https://www.colourlockaustralia.com.au/colourlock-leather-repair-kit-dye.html
    • These going to fit over the big brakes? I'd be reeeeeeeeaaaall hesitant to believe so.
    • The leather work properly stunned me. Again, I am thankful that the leather was in such good condition. I'm not sure what the indent is at the top of the passenger seat. Like somebody was sitting in it with a golf ball between their shoulders. The wheels are more grey than silver now and missing a lot of gloss.  Here's one with nice silver wheels.
    • It's amazing how well the works on the leather seats. Looks mint. Looking forward to see how you go with the wheels. They do suit the car! Gutter rash is easy to fix, but I'm curious about getting the colour done.
×
×
  • Create New...