Jump to content
SAU Community

Recommended Posts

All things being equal your engine will be more efficient so better economy but in my experience if there is more perfromance available people (like me) will translate that extra efficiency into more speed rather than better economy!!

How true, luckily for me it's the missus that uses the car for 80% of the time!

Went for a 3200km Drive on the Easter Break with the old folks, So gave the car a pretty good test

Melb->Eden, mostly Highway and some hills = 9.1L per 100km on 98

Eden->Hay, Up & Down the Snowy mountians & Highway = 10.5L per 100km on 95

Hay->Adelaide, all flat Highway = 9.5L per 100km on 95

Adelaide->Melb, fully loaded with heayy crap = 9.7L per 100km on 98

Quite happy with the results, especially the mountian pass thought i would have burned a lot more fuel on that

Normally round town i'm anywhere from 11.8-16.9L depending on my mood,

have a tendancy to enjoy burning fuel for no good reason :D only to get to the next set of lights pinch.gif

Best i've done so far is 8.6L down to Queenscliff (just me and work tools)

Did notice that the Fuel light had 10L in the tank on the highway driving, but normally has 15L left on the heavy right foot driving

Maybe its linked in with the trip computer data aswell as liquid level, could explain why people notice the Gauge level fluctuate a bit

Nice economy there :thumbsup:

A few forum members have been getting better than 10L/100km on trips recently. I reckon that's pretty darn good all things considered...

Last tank I got 300km from 50L (roughly 16L/100k).

Mixed driving, probably babied it the first quater and got 150km or so then it all went down hill as I came on boost more often.

It's a little better then what it was before I swapped the 02 sensor, was hoping for a tad more though.

I did 1000km around Northland in NZ back in January with four adults and luggage. Took 5 days and covered mainly non-highway roads ie hilly and twisty. Average fuel consumption was 10l/100km. That was what the trip computer read and was confirmed at the pump. Was reasonably happy with that given the roads and stop/start nature of the driving as we were touring around and stopping at all the touristy spots. Was also warm and wet due to the tail end of that cyclone hitting Northland over that weekend so had the aircon most of the time.

  • 3 weeks later...

Oh well guess I'll chime in and report an average of 11L per 100km, been right thru this thing making sure everthing is set & clean as it should be, new oxy sensor this week and seen a very subtle reduction. Just how one of these things roll, all bog stock, except for removal of cat and I've bypassed secondary boost to keep it down to 4-5psi - I'm running less than 98ron, no pings nor knocks, happy Nissan motor.

When I got my wagon I thought surely it can't use as much gas as my old Isuzu 2.6L carburated petrol pickup. Yep it does despite pushing less air, fuel injection etc... but yeah put your foot into it & there's the reason, ya have to pay to have that kind of potential lurking under the hood. Then there's the awd, auto & weight thing.

I'm just going to accept what Nissan has created and trust in the hundreds of dyno hours it took to develop, no piggyback control etc... gonna pour in that gas and enjoy the 700km ride I do every week till the end...

I have a very stable kind of driving style - it's my age, pinned at 100km/h, short burst passed a truck & trailer, back in line again, hate speeding tickets, dudes passing me in company 4wd utes & hiace vans burning up that company fuel like no tomorow. Don't care really just love the feel of this car cruising along and that sweet music that erupts from up front on those occasions when ya plant it.

I did a trip up to Perisher on the weekend to check out the early snow. So from the Belconnen area in Canberra up to Perisher and back again with 2 adults and 2 kids I averaged 10.6L/100km in my 2002 M35.

You could definitely tell the difference when the engine was under load. It drank the first 1/4 of a tank to get to Jindabyne and then another 1/8 of a tank just to get from there up the mountain to Perisher.

Without the family in the car I reckon I would have used a whole lot more fuel however.. Sure the car would have been lighter but I would have had a heavier foot in the car by myself.

It would be 5 1/2 to 6 hours each way... Go to Canberra down the freeway, then head to Cooma, then to Jindabyne and you're practically there.

Good thing about having a Stagea is that all wheel drive cars dont HAVE to have snow chains onboard :)

Entry into the national park is about $18/day for a car. You can buy these passes at the Jindabyne tourist information centre or at the entry into the park. There's free parking at the slopes and a good mini mall that has places to buy food, hire equipment, etc... but if you just want to dick around in the snow put on lots of warm layers, a good windbraker and waterproof gloves and shoes :) Oh yeah... take a change of socks and an extra pair of shoes. They WILL get wet and cold and you will be miserable on the way home if you dont.

I still can't get better than 11.8 l/100km. This was my last tank which included a trip to Monarto and a trip to Victor Harbour (about 300-400km of highway).

I wish I could get 10!

Maybe ARX will get worse economy because it is heavier and runs higher PSI?

It would be 5 1/2 to 6 hours each way... Go to Canberra down the freeway, then head to Cooma, then to Jindabyne and you're practically there.

Good thing about having a Stagea is that all wheel drive cars dont HAVE to have snow chains onboard :)

Entry into the national park is about $18/day for a car. You can buy these passes at the Jindabyne tourist information centre or at the entry into the park. There's free parking at the slopes and a good mini mall that has places to buy food, hire equipment, etc... but if you just want to dick around in the snow put on lots of warm layers, a good windbraker and waterproof gloves and shoes :) Oh yeah... take a change of socks and an extra pair of shoes. They WILL get wet and cold and you will be miserable on the way home if you dont.

thanks for the info :)

i might take a trip there one weekend in the winter when the snow is thick

I average 10.5-10.8 city and country. Never seems to go over that unless I'm alone in the car..

Got a 9.0 flat from Canberra to Sydney a few times, really

Banting though and not downshifting on the hills...

P.s - PhoenixPup, I'm based in Canberra too, southside

Sean

On the economy front I don't really have any impressive stats to post, best I get is probably around 13l per 100km because I do alot of short trips and traffic, but what I will add is that I've had a large improvement since installing an apexi safc 2, have it set up to really lean me off when on low throttle and it works great very pleased with it and would recommend to anyone who is running a bit to rich.

On the topic of snow forget Australia it's ludicrously expensive and crap compared to elsewhere, give NZ a go MUCH better and seriously about the same price ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • You will now be able to lift the parcel shelf trim enough to get to the shock cover bolts; if you need to full remove the parcel shelf trim for some reason you also remove the escutcheons around the rear seat release and you will have to unplug the high stop light wiring from the boot. Next up is removal of the bracket; 6 nuts and a bolt Good news, you've finally got to the strut top! Remove the dust cover and the 3 shock mount nuts (perhaps leave 1 on lightly for now....) Same on the other side, but easier now you've done it all before
    • OK, so a bunch of trim needs to come off to get to the rear shock top mounts. Once the seat is out of the way, the plastic trim needs to come off. Remove 2 clips at the top then slide the trim towards the centre of the car to clear the lower clip Next you need to be able to lift the parcel shelf, which means you need to remove the mid dark trim around the door, and then the upper light trim above the parcel shelf. The mid trim has a clip in the middle to remove first, then lift the lowest trim off the top of the mid trim (unclips). At the top there is a hidden clip on the inner side to release first by pulling inwards, then the main clip releases by pulling the top towards the front of the car. The door seal comes off with the trim, just put them aside. The the lighter upper trim, this is easy to break to top clips so take it carefully. There is a hidden clip towards the bottom and another in the middle to release first by pulling inwards. Once they are out, there are 3 clips along the rear windscreen side of the panel that are hard to get under. This is what the rear of the panel looks like to assist:
    • Yes. Autos typically work from the speed sensor on the pinion shaft of the diff. I also think that even if you have a proper speed sensor for the bog manual in the manual box, that the signal it outputs is not compatible with the auto dash anyway. You should consult that manual (the book, not the gearbox).
    • And I just realised that that advice is slightly nonsensical for a GTR, because you need 2 of them. But it is otherwise true.
    • Having had a reasonable look at the car, I'll be able to remove the (one time) rams and retract the hinge (they are held in the down location by a tiny (m3?) sacrificial screw) which will get it physically back in shape. From there if you remove the rams you need a resistor to turn off the airbag light (as Mark said, there are plug in kits and I might go that way because its reversible). And...per all the threads on here, even if you have the resistors to turn off the airbag light, the bonnet light will stay on as it writes to the airbag computer history - that is either replace the airbag controller, reprogam the EPROM (if I can work out how), or remove the globe from the dash. Having seen how sensitive this system is, if I had my time over I'd pre-emptively remove the rams, even on a road car, because this is all a very unnecessary pain in the arse. Reminds me, time to go and have a look at the Fuga too....
×
×
  • Create New...