Jump to content
SAU Community

Recommended Posts

Thanks guys. I just gotta find a way to get the power down now.......

Good luck with you build Dave! You got a thread?

Just weld her up.... She'll be right.

... as long as you only live your life a 1/4 mile at a time that is.

  • Like 1

+1 for not doing a Greg

Especially at 'normal car' levels cause that's what I did

Repeat

Do not do a Greg

Also, turbo size looks matched pretty well with the engine, great result, and I am 100% sure and would bet my life Scotty actually said "SEE MATE I TOLD YOU WOULD MAKE MORE THAN 100KW haw haw haw"

He hasn't seen it yet Greg but he will say exactly that lol.

Thanks for the love guys.

Got a new old bonnet today, changed the pads to a1rms, new thermostat an rebuilt drivers side calipers.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...