Jump to content
SAU Community

Recommended Posts

Looks like a GTS thats had an RB20 swapped in which is fine, but its still stupid cheap for the US Market. 

I think youll find R32 GTSt are going for between 10 and 15k, so 5 sounds scarily cheap.

Did they have a picture of the VIN plate from the engine bay by the way?

On the plus side, you could run Longchamps on the car haha

Edited by Hcr32typem

My biggest worry would be it being a theft vehicle at that price honestly. 

Second biggest worry would be serious mechanical defect or a badly done swap, as again, that looks like a GTS with an RB20DET put in

Edited by Hcr32typem

That car is listed on there about 3 or 4 times... the link above indicates the "bidder" didn't pay, so the $5KUSD could be a starting bid not buy out price, another listing has an actual price of $14,990USD...but also claims a clean title and lists the VIN so you could do some more research.

Regardless, I wouldn't touch it as per all the above comments, unless you want to confront the seller with the knowledge it's not a gts-t and lowball him for trying to pass it off as something it is not.

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...