Jump to content
SAU Community

Recommended Posts

Have you done brake lines as we'll? Very interested in doing this

haven't done the brake line. Tried to look for it locally but could find it unless custom made. But so far changing the fresh brake fluid and cusco brake stopper really helps.

Last couple of weeks installed new upper rear ajustsble control arms, new bushes for rear sway bar , new front sway bar bushes, and a new battery on Thursday, got one of those new green battery's from battery world

Going to tackle cleaning my coils and putting electro paste on them to see if I can resolve my miss around the 5k rpm mark

keep us posted on the electro paste results, as far as i know in bad situations the spark can leak and ground into the head area

Headgasket lifted slightly in two spots so engine is out on the yellow pig. While out I will take advantage and replace a few hoses and bibs and bobs while on a stand.

The good news is that the bores look pristine with minimal carbon build up. Not as pretty as an ethanol run engine but not too bad given the number of kms, number of dyno runs and the abuse by Ms Wolv (just daily driving in Sydney) for all those years. While it is out we will refresh with OEM rings and ACL race bearings.

The head is being pressure tested before a complete head service and we can tighten up the valve clearances a whisker to get rid of the slight intermittent tick that has been there since the poncams were installed.

Picked up the stagea today from the panel shop after getting rear ended a week ago. Very happy with the work they done, plus now I am de-badged

Are there any pin holes under the badges other then the Nissan? Id like to remove the AXIS & Autech bagde if possible.

Are there any pin holes under the badges other then the Nissan? Id like to remove the AXIS & Autech bagde if possible.

No there isn't, But there is another issue just as big really. From factory they put the badges on while the pain is still soft. So if you remove the badges with out sanding back and respraying it, you will have raised edges around where the badges used to be.

No there isn't, But there is another issue just as big really. From factory they put the badges on while the pain is still soft. So if you remove the badges with out sanding back and respraying it, you will have raised edges around where the badges used to be.

Really the best way to go is to arrange to be rear ended like Josh has done & have your car debadged when it is being repaired.

When I did mine that way a few years back I was given the badges on a cool template to allow me to stick in exactly the right place should I ever get the urge to rebadge.

BTW Josh, I'm no photographer but the potato you used to take that picture of your car needs its lens cleaned, or a steadier hand or something. :)

  • Like 3

Really the best way to go is to arrange to be rear ended like Josh has done & have your car debadged when it is being repaired.

When I did mine that way a few years back I was given the badges on a cool template to allow me to stick in exactly the right place should I ever get the urge to rebadge.

BTW Josh, I'm no photographer but the potato you used to take that picture of your car needs its lens cleaned, or a steadier hand or something. :)

Lol yeah there isnt much light in my carpark. Plus I couldn't be bothered re taking the picture

Written off due to to expensive to repair

Buy it back, and repair; an uneconomic repair write off isn't a statutory write off.

Stupid insurance companies...

Is this the point at which insurance companies become (even more) hypocritical? Surely they couldn't ask much for it at all otherwise they would have spent almost up to the insured value repairing it. I had an offset head-on way back in 1992 (man I sound old now) in a car insured for $8K and the insurers repaired it and gave it back, yet the damage must have been very close to $8K.

Buy it back, and repair; an uneconomic repair write off isn't a statutory write off.

Stupid insurance companies...

IF he wants it back of course.

I had the option of buying my Stagea back for $5k which I declined then watched it sell for under $2k at pickles. Bargain.

Could have fixed it but wanted the PM

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • My experience with Rising Sun Exports Before agreeing to the sale I tried to do as much research as I could (obviously), his Facebook reviews are 98% and he goes Live at least once or twice a week. I contacted 2 people in the UK who had used him for their imports, both had positive feedback. His explanation and talk through of the import process was thorough, answering any query no matter how stupid it was. It felt as soon as the money was sent, communication dropped off. I asked for shipping updates every 2 weeks or so, not wanting to pester him, he never had any updates. I wasn't informed the car had been dropped off at the port, I only found out by his Facebook story. I asked for the photos taken at the port, knowing he would need some for insurance purposes. I received a few 5 second clips and that's it. When asked again, he said his staff had them. Weeks later I asked again, he tells me he doesn't have any, but does have 50 photos from the original advert. I never received them. I eventually got the documents sent via WhatsApp after I mentioned the port was requesting them. I purchased a CarVX report, to find out the vehicle is a Grade R with recorded accident damage, first recorded in 2017 when it was first auctioned. He never told me the grade, then again I didn't ask. His response was "Grade R means nothing, it wasn't chassis damage". Still, I would have liked to have been informed about it. Jon prides himself on being open and honest when it comes to inspecting cars, it's his main job doing so at the auctions for customers. When the vehicle arrived in the UK I noticed a few little cosmetic issues. It's a 21 year old car so it wasn't going to be mint condition. The side skirts are cracked on each corner and the sealant is failing. The front grill on the bonnet/hood isn't secured very well, mounting studs are missing. Both minor things, but again, it would have been nice to be told. During a Facebook Live walk around video of the vehicle, he mentioned it has a front Whiteline anti roll bar/sway bar. While on the inspection ramp, I noticed the stock item has been installed. When first questioned, his response was "the ARB? Switched? Since when, it never had them". Since sending video and photo evidence I've not received a response. I'm probably being over critical of the overall condition of an old car, but all I wanted was honesty (which he claims to have). I'm aware I wasn't his only customer, he's busy doing XYZ but other reviews praise him for great communication with regular updates and photos, I felt I didn't receive the same treatment. 
    • I was able to get some underside photos while the car was on the ramp The suspension is all Altezza/IS200/IS300 so getting part's will hopefully be less of a headache
    • Welcome to my 2004 Toyota Mark ii IR-V Fortuna (series 2) With a 1JZ-GTE powerplant under the bonnet (hood) it'll give me plenty of scope for power upgrades. For those who aren't familiar with imports, the 1JZ-GTE is a 2.5L 6 cylinder VVTi engine with a single turbocharger. This has the factory R154 5 speed gearbox, along with a aftermarket 2 way LSD differential (brand unknown). Under the arches are a set of CST Zero 1 alloys, 18x9 +30 225/40 up front and 18x9.5 +15 265/35 on the rear. The car was quite low in Japan and there's evidence of the wheels catching the rolled arches/fenders. The tyre's aren't great so I'm in two minds whether to replace both or just the tyres and put up with the wider wheels on the rear. The car still uses stock brakes with the addition of some braided hoses. The exterior is stock with the exception of a BN Sports front bumper and a replacement Fortuna grill  Moving to the interior, the steering wheel has been replaced with a dished MOMO steering wheel (which will get swapped for my Momo Tuner for the time being) Defi Link Gauges are mounted above the climate controls and on the A pillar, the Oil Temp,Oil Pressure,Water Temp and Boost gauges should help with spirited and track driving  The stock seats have been replaced with some retrimmed Recaro bucket seats. Being a larger build these are a little snug, unfortunately the orange isn't for me so I'll look into replacing these down the line. Other modifications include a twin plate clutch, Blitz intercooler, Evolve alloy radiator, a stainless exhaust with decat, HKS EVC-S boost controller and coil overs
    • Apologies for the long read My R34 GTT was up for sale at the beginning of spring due to a few repairs creeping up. The strut tops needed replacing, roof and bonnet (hood) painting (yay for 3 stage pearl) and the underside stripped and treated. I sold the car which allowed me to be in a much better place financially. Leading up to the sale I was already thinking about the replacement. In an ideal world it needed to be a good all-rounder. Something I can mess around with, modify, do track days, do the school run, go on long drives etc.  Options included but not limited to... Laurel C35, Evo 8/9, Civic FD2, Impreza Hawkeye, Aristo and even an Audi S4 Avant (I've already got the Mazda 6 wagon). But there was always one car at the top of the list The Toyota Mark ii JZX110 I found an advert on a Facebook group for an example in Japan, from a seller called Jon at Rising Sun Exports. A few messages back and forth and Jon calls me from Yokohama one morning (or afternoon in his case). He briefly explained the import process, the costs involved and a repeat of the advert. After much deliberation, the price was agreed and the sale was locked in. I've never imported a vehicle so I jumped into the unknown head first. The money transfer was completed through wise.com (fees apply), very easy to use and the money was with him within a day or two.  The car suspension was raised for the vessel and the car dropped off at the port. It was 7 weeks later when the bill of lading was received and the freight invoice sent to me, followed by the export certificate a couple of days after (both digital copies) In the mean time the port had been in contact. I needed an agent to deal with the NOVA (notification of vehicle arrival) along with the tax/duty invoice, this was £75.00. The port also had a fee of £100, I'm guessing to cover the cost of the 10 day 'free storage' and for moving the car off the boat etc. They need a copy of the vehicle invoice, freight invoice and export certificate to allow the vehicle to pass through customs. The vessel arrived on Tuesday 5th August, the tax/duty invoice was generated and sent over. This is generally tax 20% and duty 10% of the vehicle value. Although the invoice came in at a higher amount than I had calculated. Once HMRC had received the payment the vehicle could be released from customs. I thought once the tax/duty was paid you could collect at any point, that's not the case. Your agent will need to book a collection slot, I requested Thursday 7th which was accepted, with a 9:00am slot allocated. It was a 5:00am start from Norfolk heading to Southampton. We eventually found the compound, upon presenting the bill of lading and some ID they released the car (they drove it out of the compound to the front ready for us to load up). The email from the port stated each slot had a 10 minute window, which seemed abit farfetched but the staff said it's not a strict rule. We were there for approx. 30-40 mins in total. A week prior to collecting I contacted my garage and explained the situation, I was able to get an inspection slot that afternoon. For the registration, DVLA require the car to be insured, for this I used a company called Adrian Flux who can insure the vehicle using the VIN number. 
    • Hey guys, looking for these side skirts if anyone can help me out. 
×
×
  • Create New...